Electronics Forum | Mon Nov 02 08:24:44 EST 2009 | rgduval
Umar, We don't think you've violated ESD handling in the manner you've described. If your employees were wearing foot straps, and your floors are conductive/grounded. I've run into this at multiple companies, where transporting the PCBs station
Electronics Forum | Sun Dec 06 14:22:24 EST 2009 | Dany
We use Photondynamics SV-7550 now. We want to upgrade our AOI because we found that SV-7550 are not very good to detect solder defects. I send samples boards at each company with the solder defects that i can't detect with my Photondynamics SV-7550.
Electronics Forum | Fri Mar 19 03:13:35 EDT 2010 | mun4o
Hi, First check what the Moisture Sensitivity > Level of the LEDS is....you may need to ask the > LED manufacturer. Once you've established it is > moisture sensitive then follow latest version of > IPC JEDEC 33 spec. for storage of them and dryi
Electronics Forum | Fri May 07 00:52:24 EDT 2010 | boardhouse
Hi Derek, just curious of one thing - are the vias within the BGA's the only vias covered or are all vias on the board covered. Just trying to figure out what is making this area different from the rest of the board. Regarding leaching, I do not be
Electronics Forum | Wed Jul 14 13:41:40 EDT 2010 | rway
We are running SMT products and have been for some time now. First, I wanted to check with you folks to see what an acceptable FPY rate, or what you would consider and acceptable rate, is. Secondly, we are having issues primarily with product that
Electronics Forum | Thu Mar 10 21:21:54 EST 2011 | thatguy
I have 7yrs experience with JUKI's and I liked 2000 series(2050,2060) dont get caught up in the 730 or 760 these machines are obsolete or at least on there way and spare parts are hard to come buy. The 2060 is the chip shooter. I like the user friend
Electronics Forum | Fri Nov 04 22:12:57 EDT 2011 | machinehead
I know what you mean but have never found a tool > that would do this sufficiently. For higher > value parts you should keep them in a bag for the > next time you run a job that uses that part and > hand fit them. > > The nature of the feeders
Electronics Forum | Wed Nov 16 17:30:29 EST 2011 | olddog
Hi again Bobpan, One thing I noticed when I pulled the z-rod to inspect it was that it was "bearly" finger tight. When I replaced it, I snugged it a bit better (not overtightening). After resuming setting up additioanl placements (this board requires
Electronics Forum | Sat Feb 18 09:20:09 EST 2012 | davef
The 3-Tier PCB library concept was originally created by IEC (International Electromechanical Commission) in 1999 and introduced to IPC in 2000. The concept had to be created as a solution for high density packaging for hand held devices to ruggedize
Electronics Forum | Wed Jul 04 09:58:50 EDT 2012 | daxman
Assuming that you have a saturated moisture-sensitive component: At what temperature would popcorning or internal component damage occur? I would guess that it would be at a temperature where water would boil, around 100 degrees? However, the JEDEC J