Electronics Forum | Fri May 05 17:12:41 EDT 2023 | ttheis
I am in the Milwaukee area. I just added a photo to the post; must not have done it properly the first time.
Electronics Forum | Thu Jun 08 20:26:15 EDT 2023 | cbeneat
My company uses MPulse. Not terribly complicated. Inputting all the assets, Inventory, Instructions for the task etc. is time consuming in the beginning, but worth it.
Electronics Forum | Fri Jun 16 17:42:40 EDT 2023 | robertobsuinc
Hi, Is there any accesory we can get from my data to place caps vertical on the board but are horizontal in the reels? Is taking to much time hand placing the parts, we would like to automate
Electronics Forum | Mon Jun 19 07:50:03 EDT 2023 | tommy_magyar
What I would ask before actually answering your question is, what is the smallest footprint/pad which can be pressure dispensed/jet printed? Regards, Tom.
Electronics Forum | Mon Jun 19 10:30:30 EDT 2023 | smtusa
Jet printing can reach 80um, whereas contact dispensing is 0.3mm I believe. 0402 pads are 0.6x0.5mm.
Electronics Forum | Mon Jun 19 12:46:11 EDT 2023 | daniel_stanphill
And I can set deposits down to 34 um on our my500. I do not have the exact numbers in front of me on the my700 or Essemtec, but they will both be better than that.
Electronics Forum | Wed Jun 21 12:51:58 EDT 2023 | previnmoore
The Juki is showing and error code of 696007 and is also saying to go to the control panel to set date and time which is not letting the machine run.
Electronics Forum | Wed Jun 28 12:04:28 EDT 2023 | nickadams
Thank you for your input. Do you know what might have caused this to happen? Just trying to prevent it from happening next time.
Electronics Forum | Wed Aug 23 20:23:44 EDT 2023 | davef
I check the FORUM several times a day and delete what I find. Just email me when I miss something or am tardy.
Electronics Forum | Thu Aug 31 18:48:25 EDT 2023 | SMTA-64387600
I presume you have a local flux spray with your selective solder machine (I have no idea what you use). If I have a group of leads in close proximity like this, I would be trying to design a well and nozzle setup that I can use to solder all the joi