Electronics Forum | Mon Mar 20 08:36:30 EST 2006 | jdengler
I've never had this problem on an Omniflo oven, but have seen it on others. It has always turned out to be mechanical. A bearing going bad or FOD in the rails. I would pull the chains and carefully check each link of both chains, all of the bearin
Electronics Forum | Mon Mar 27 11:03:06 EST 2006 | mapell
Tribol 1430 is the latest generation oil, 930 can't take lead free temps. Please see the following link.... http://www.castrol.com/castrol/productdetailmin.do?categoryId=82958955&contentId=6004371 If your getting alot smoke and residue, reduce the
Electronics Forum | Tue Mar 21 21:24:48 EST 2006 | alphaman
I recently acquired an older Dover Soltec 6522/23cc wave solder machine. The machine appears to be in good working order and I thought I would get it running to use as a backup. Can anyone tell me where I might get an operators manual. I have the
Electronics Forum | Wed Mar 22 03:00:09 EST 2006 | meritajs
Hi All, We have problem with Zevatech FS-730 This machine shows error E202062: "System error: T axis of head: Parameter error when T axis performs PTP action.(Kind of unit)" and it stop running. It does not pick up components. At low speed it works s
Electronics Forum | Sat May 27 12:50:14 EDT 2006 | GS
HI, just my 0,00001 cents Which preheat system does your wave solder has? for instance ? - IR ? - Bottom only ? - IR + Forced Air ? (bottom) - IR + Forced Air (bottom) IR top ? PCB thickness ? Appropriate preheat is important when looking to f
Electronics Forum | Fri Apr 21 23:28:54 EDT 2006 | SD
Sounds like you have a non-IQ system? If you can, get one! It makes life much easier. Costly, though! Anyway, as stated above, your best bet is to assign multiple boards to the same table top. If the two boards are 99% similar, use a full opti
Electronics Forum | Mon Apr 24 07:37:57 EDT 2006 | craig_83
We have the IQ system. The problem that I was having is that when I load one board to the other, I want to avoid the table top changeovers. So I figure if I can make certain tabletops to run certain boards the changeovers would be much less. I though
Electronics Forum | Wed Apr 26 11:46:34 EDT 2006 | Dr. Timothy J. Harpster
I have spoken to the people at Manncorp and was not impressed. Their units are significantly cheaper than some other comparables on the market but from my conversation with them I am sure there is a reason for the reduced cost. We have decided to go
Electronics Forum | Tue Apr 25 12:29:35 EDT 2006 | Rob
Hi TMC, It's very unlikely that you'll get a temperature variation of 32 degrees by varying the top and bottom heaters - especially if it's forced air convection, as if it's a half decent system the hot air will be circulating in the zone, pretty qu
Electronics Forum | Thu May 04 02:07:44 EDT 2006 | CW
Hi, There are a couple of Omniflow 7 and 7E that are being used in the production. Recently we found a lot of flux clogging up the exhaust ducts. Anybody who uses the same type of tool who has seen this kind of problem? How can we fix this? Does