Electronics Forum | Fri Nov 19 10:26:47 EST 2010 | cyber_wolf
We use copper anti seize on the ball screws in our PBfree reflow ovens.
Electronics Forum | Thu Nov 25 18:31:41 EST 2010 | padawanlinuxero
I am with MYDATA, I have seen Samsung work not work with them directly, right now I have two SMT lines and we are ok, and they are very flexible to run with samsung is not that flexible.
Electronics Forum | Wed Nov 24 14:36:14 EST 2010 | jamyboy
Looking for opinions on what the best bang for the buck is for MDA in a high mix low volume lean environment? Is it AOI or Flying probe?
Electronics Forum | Mon Nov 29 11:47:06 EST 2010 | davef
While you're waiting for others to reply, look here: http://www.smtnet.com/Forums/Index.cfm?CFApp=1&Message_ID=28458
Electronics Forum | Fri Nov 26 10:28:09 EST 2010 | cruoff
QA Error #0 The strange part is that if I reprogram the Pickup over and over again, using the same variables, eventually the error goes away and does not return for that particular pickup. However it will occur again for subsequent pickups. Has
Electronics Forum | Mon Nov 29 16:28:24 EST 2010 | jmw
If i remember this correctly....and its been years.......check to see what your theta number is for the pickup or placement. The number has to be 1 of 4 values.
Electronics Forum | Mon Nov 29 12:57:33 EST 2010 | cyber_wolf
We are looking at doing gauge R&R studies on our placement equipment. I know that IPC9850 cites the test vehicles and test parameters. One thing that we are not clear on is what gets used for an external measurement device. Any input would be greatl
Electronics Forum | Mon Nov 29 18:23:19 EST 2010 | comprep
Has anyone had any success with placing BGAs with the Quad QSP-2? We have been having alignment issues with BGA placement but our placement of 0402 parts is dead on. We have worked through the calibration and it seems to be correct.
Electronics Forum | Mon Nov 29 20:33:08 EST 2010 | jucki
Dear all Can any1 explain me about the variuos types flux and their cleaning procedure? I have confusion in claen,non-clean,RMA, and water soluble. Thanks in advance.
Electronics Forum | Tue Nov 30 13:01:21 EST 2010 | patrickbruneel
There are also No-Clean/No-Residue fluxes where the flux gets eliminated by the heat of the soldering process (this eliminates “does not look pretty” in hegemon’s post). Patrick http://www.interfluxusa.com
