Electronics Forum | Mon Dec 04 18:12:45 EST 2006 | Say
Does anyone have a tpsys 1.4.7 software or the servo? Please contact me at sbounsavath@rad-tech.net or call me at 818-381-8500 ext.555. -Say
Electronics Forum | Thu Feb 24 20:45:01 EST 2000 | Todd Woods
1.4 seconds. We found a step function decrease at 1 second.
Electronics Forum | Wed Dec 19 14:02:18 EST 2007 | gersla
We decided to bake components in tray package at 70 Degree prior soldering. I am looking for suggestion regarding baking time for MSL3 components: Up to 1.4mm package thickness 1.4-2 mm thickness 2-4.5 mm thickness In JEDEC-033B this temperature is n
Electronics Forum | Mon Jun 26 03:00:15 EDT 2000 | armin
Hi, Anybody there running GSM1 UPS Rev 1.4 with OS/2 4.0 Warp ? We have OS/2 2.11 and we plan to upgrade to OS/2 4.0 Warp. I'm afraid of some incompatibility issues might occur. Please feedback any incompatibility issues you encountered in case you h
Electronics Forum | Mon Dec 20 09:46:21 EST 2010 | azbvc
I have to make a few fixtures using durostone Material. I would like to know what end would be best to use for milling pockets out. I tried using HSS 1/4 in all I did was burn it up. Also I tried to use a 1/4 " carbide end and burnt that up too. any
Electronics Forum | Fri Mar 23 19:50:57 EDT 2007 | Frank
Possible head combinations to pick from multiple 12, 16, or 24mm feeders. Note: you can not mix feeder sizes for simultaneous picks. KE-2010 and KE-2050 will use 1&3, 2&4, or 1&4 KE-2020 and KE-2060 will use 1,3,R or 2,4,R or 1,4,R I prefer to s
Electronics Forum | Wed Jun 10 22:31:07 EDT 2009 | mgcoope
At work we use a system in which every customer uses a part with a phantom ( top level ) part and then under that we have more part numbers that are valid. So something like a surface mount resistor would be stored as something like. PPPPPPPPPPPP
Electronics Forum | Thu Dec 12 21:44:15 EST 2019 | davef
I don't know what a "mass defect" is. Defects are within AQL [acceptable quality levels] or they aren't. I start at General Inspection Level 2 in the AQL Chart ANSI/ASQ STANDARD Z1.4-2006 and a sampling plan ANSI/ASQ Z1.4 Adjust the Level for Budge
Electronics Forum | Tue Jun 23 22:14:16 EDT 2020 | kumarb
Hi. Guessing that you are operational by now? If not, consider to use BGA definition and use the editor to define where the bottom side pads are or are not. Just our 2 bits input. The Assembleon X / Yamaha units are quite flexible - using an electron
Electronics Forum | Wed May 13 17:46:09 EDT 2009 | cusackmusic
Does anybody have any recommended Clinch/Length values for: 1/4W Resistor 1N4007 Diodes 3W Resitors (A bit bigger than 1N4007 leads). Thanks, Jon