Electronics Forum | Tue Jan 03 13:45:14 EST 2012 | adlsmt
What would be the best router to use that would allow clearance on the top side for large components and long wires on the top side of the board? High volume so must be fast.
Electronics Forum | Tue Jan 03 15:08:36 EST 2012 | joetest
I need a clean and simple-to-remove part that will temporarily connect one portion of a board to another portion .25" away. The ideal jumper wouldn't require desoldering or leaving parts behind, like a fuse holder. Is there such a thing?
Electronics Forum | Mon Jan 09 17:21:52 EST 2012 | davef
Your pictures are 1600X1200 JPEG. That's like 900k. Try saving them as 640X480 JPEG
Electronics Forum | Fri Jan 13 06:10:46 EST 2012 | thanh
We had same trouble with one after 1 year, send back to repair, cost $100. look like it okay for now.
Electronics Forum | Thu Jan 26 14:36:16 EST 2012 | carvincorp
Thanks for the replies. We have purchased a spare frame so if it happens again, we won't be stuck waiting for a repair. Good info about the burr that was causing a repeat leak- I will keep that in mind if it happens again.
Electronics Forum | Wed Feb 15 10:21:54 EST 2012 | caerleon
You can buy the kit from DEK direct and it contains self assembly instructions, changed ours in under 15 mins - no need to send it back for repair. Key for durability, is using the correct pressure!!!
Electronics Forum | Wed Jan 11 13:01:54 EST 2012 | davef
It depends. * A common bare PCB IS NOT ESD sensitive and is a static generator * A less uncommon PCB with embedded parts IS ESD sensitive and is a static generator
Electronics Forum | Thu Jan 12 13:18:07 EST 2012 | swag
215 to 220 deg.C peak reflow. We bake then store all PCB's in low humidity cabinets (appox. 3% RH) prior to running.
Electronics Forum | Thu Jan 12 11:41:02 EST 2012 | babe7362000
We are recieving many QFN's in Tubes instead of trays and tape. Does anyone have luck with these in a tube feeder, or vib plate? We cant justify to order a full reel because the cost of the part.
Electronics Forum | Thu Jan 12 15:36:59 EST 2012 | swag
I've got specialized tooling I'm building for SMT processing. It requires a 0.125" thick sheet of high temp. silicon rubber cut to shape. Does anyone know of someone who can cut silicon sheets to a specific pattern/design?
