Electronics Forum | Wed Mar 06 07:13:23 EST 2002 | PeteC
nope, only placed 0.75mm pitch myself. I looked around some data sheets and did not find any 0.4mm.
Electronics Forum | Wed Mar 06 21:20:36 EST 2002 | davef
We are aware that 0.4mm parts are coming [ http://www.kns.com/prodserv/flipchip/products/roadmap-ultracsp.PDF ], but are assembling none at the present time. We�re in no rush!!!
Electronics Forum | Wed Mar 06 21:19:10 EST 2002 | davef
As an alternative, consider: * Asking your operators. * Having your operators keep logs and checking them with hands-on time studies.
Electronics Forum | Wed Mar 06 10:24:32 EST 2002 | Charlie
Here our senerio: * There are no funds for additional test equipment. * Have only Delta Scan results, that are very limited. * Failuer of Delta Scan, PCB goes to vendor for X-ray analysis. Do you have a similar process and do you do anything diffe
Electronics Forum | Fri Mar 22 09:11:57 EST 2002 | tony
Hi Chinaman For more informations please contact Mr. F. Parent Ing at specnor tecnic corp. Best regards Tony
Electronics Forum | Thu Mar 07 09:46:36 EST 2002 | cfraser
If you are having problems with missing, misplaced RLC on your Fuji CP you should take a look at your board supports in the machine. Lack of or improper board support and bad feeders are the most common causes of misplaced RLC's.
Electronics Forum | Sun Mar 10 23:51:47 EST 2002 | mantis
As well as checking board supports you may want to check your nozzles and make sure there not stuck up in the windmill.
Electronics Forum | Fri Mar 08 12:22:18 EST 2002 | pr
Have you contacted Fuji? I believe we had the same situation a while back and (I think) it was a proper setting and not a sensor problem. A tech. can probably walk you through it over the phone. good luck, pr
Electronics Forum | Fri Mar 08 22:07:31 EST 2002 | winter
I think the reason of the problem is the sensitivity of some sensor.maybe it's the main conveyor arrival sensor .I think you can do a test , make the sensor always on, and tese.
Electronics Forum | Thu May 23 03:14:30 EDT 2002 | ianchan
RDC, so you favour which type of AOI technology? you prefer: 1) vector analysis? 2) image-scan-comparision? and what advantages support this choice of yours?
