Electronics Forum | Fri Jul 18 16:04:31 EDT 2014 | comatose
We had this. The anti-backlash nuts were binding. We took them apart, chased the threads with a tap and re-assembled with slightly less pre-load. Hasn't been a problem since.
Electronics Forum | Sun Jul 20 14:55:25 EDT 2014 | bobpan
Typically when this happens the lighting in your package for a part in one of those cycles has 0 0 0 in the 3 light settings. You need to check all your package types that are used in your program and makes sure they are adjusted correctly. Good Luc
Electronics Forum | Sun Sep 21 15:35:42 EDT 2014 | gascon5383
not sure what the older type is. i have the manuals for topaz xii version. im assuming thats newer than what your looking for but let me know.
Electronics Forum | Fri Jul 25 09:54:00 EDT 2014 | emeto
Hello all, what is your opinion on step stencils. Is it better to have the step on the squeegee side or on the bottom side of the stencil? Why you do it this way? What are the advantages and disadvantages?
Electronics Forum | Tue Jul 29 07:24:03 EDT 2014 | jandon
I think you need step on the bottom side of the stencil (undercutting) only to compensate elevations on the top side of the PCB, such as labels.
Electronics Forum | Wed Aug 06 22:36:27 EDT 2014 | padawanlinuxero
Not an expert, so bear with me, but I think that depends on how much components are in the vicinity of the pads you want to step. Hope this pdf helps Cheers!
Electronics Forum | Wed Aug 27 15:53:05 EDT 2014 | smtdoug
I always put the step on the squeegee side. You'll get some "shadowing" effect on any parts in close proximity to the stepped up region. It should be manageable with proper board / stencil design.
Electronics Forum | Sat Jul 26 12:37:10 EDT 2014 | jimmyboz
In the future, please try to explain the situation with some detail. Usually this is the sensor on the 10th station to verify to nozzles are in the up position.
Electronics Forum | Fri Aug 01 13:04:36 EDT 2014 | bmalhi
Yes, please contact us here at the Heller Service Dept. on 973-377-6800 EXT. 5 And we will be happy to assist. Best Regards, Bilal
Electronics Forum | Fri Sep 05 08:54:09 EDT 2014 | oxygensmd
My problems was solved. I needed to recalibrate the sprinkler. I used the service account and adjusted the settings in the sprinkler setup window. After a few test it work perfectly. Thanks for help guys!