Electronics Forum | Wed Mar 26 09:26:12 EDT 2008 | lloyd
I know you said you checked your clamps but another look will do no harm. we had a very similar issue a while back, and it turned out that the plastic shim under the chase clamp magnet was damaged. This caused the chase clamps not to release properly
Electronics Forum | Fri Feb 16 17:04:17 EST 2024 | jborrelli76
Thanks, will do. The point that's odd is one side functions. I think there may be a cable that causes each bank to clamp that may be broken. Time to get my hands dirty...
Electronics Forum | Fri Feb 16 21:51:15 EST 2024 | jborrelli76
I was correct...the cable that operates the stencil clamps on the right bank is severed...do you know where I can get a replacement cable part number 163368? Thanks.
Electronics Forum | Mon May 05 08:42:35 EDT 2008 | mmjm_1099
We use double image stencils with our DEK Horizons. My operators would just load the pcb on to the rials and manually adjust the stencil and clamp it. Once they do that they add into the comments what number the handcrank adjustable is at so next tim
Electronics Forum | Thu Oct 04 00:10:15 EDT 2018 | gaintstar
flason smt wave soldering machine: http://www.flason-smt.com/product/SMT-stencil-printer-Dek-Y-Axis-Motor-133128.html http://www.flason-smt.com/product/SMT-stencil-printer-spare-parts-Dek-Camera-181054.html http://www.flason-smt.com/product/SMT-stenc
Electronics Forum | Thu Aug 23 10:16:43 EDT 2012 | dontfeedphils
There are a couple of things that I would check. Check the board clamps and make sure that they're in good shape and that they're actually holding the board securely. If those check out I would take a look at the fid camera and make sure that every
Electronics Forum | Wed Jan 11 06:29:47 EST 2012 | cbeneat
We have Vectorguard frames we've been using for about 6-8 months. We've seen no leakage on ours. The frame has written on it an operating pressure of 101.5-116.0 psi,our pressure is set a lot lower, 50-60 psi, as we also use another frame that can'
Electronics Forum | Mon Sep 03 22:58:55 EDT 2001 | Poon Man
Hi Steve, Our China plant is using DEK 288. The cycle time is very impressive. However, there are some imperfections make our engineers feel bother. Maintenance is a big problem. As the machine was discontinued, the immature design was not improved.
Electronics Forum | Mon Mar 24 14:19:36 EDT 2008 | burb1999
I have a DEK ELA and here is what happens. I print a board after going through the step and it is a dead on print. Then, with another print it will be off in Auto mode (sometimes up and sometimes down, seems to just be up and down not left to right
Electronics Forum | Mon Mar 15 23:00:40 EST 1999 | Dave F
| In the early days, we used screens made of stainless steel or polyester. Sometimes - after A period - the tension was not good, because A wire was broken. | Later on we started to us metal stencils, glued in A polyester screen. even than we had som
.gif)
