Electronics Forum | Mon Aug 04 21:50:24 EDT 2008 | jti
We're running only our second job on our newly aquired Juki 740 The problem I'm having is as follows, I program the locations, component info, pick info, all fine. When I have the machine measure the component, everything comes up fine, it returns t
Electronics Forum | Wed Feb 01 00:10:32 EST 2006 | kent
Are you seeing this problem with the nozzles after an error stop? Well check station 15 confirm nozzle clutch origin. It will cause this problem. If you rotate a shaft (with the machine stopped) 45 degrees and start you will get return theta off and
Electronics Forum | Fri Aug 02 08:12:55 EDT 2019 | dfl
Hey guys, I'm using my Quad IV-c for a while now and I already manage to run some batches, but I never used the "Quad Align" feature before, since almost all my boards are 1206 parts, that doesn´t need a ton of precision to align. Anyway,
Electronics Forum | Thu Mar 21 12:09:28 EDT 2019 | alexcouto
Hello Bukas, thanks again. Since at an early stage I switched heads # 1 and # 6 and they are not compatible, then I went through the manual and figured out why. in order to start at the beginning and check that it had not damaged anything, I put the
Electronics Forum | Wed Sep 04 13:58:36 EDT 2019 | smrsteve
Hello Bobpan, Thanks for the response. 1. Function 30 gives me a consistent 182-185, even after nozzle changes. I can vary this by changing mod code 15 and I have been advised to aim for 90-110, but it doesn't seem to make any difference so I've go