Electronics Forum | Tue Sep 19 13:39:36 EDT 2000 | Dave F
No nozzles!!! Cool!!! We buy nozzles, like jelly beans. In a low volume, high mix shop how does the total cost of ownership match-up with a high-end air rework station?
Electronics Forum | Tue Jul 13 10:51:55 EDT 2010 | muarty
Sounds pretty much like the sensors/amplifiers need tuned on your machine. It is a fairly straightforward exercise to do this. The sensors basically look at the back of the chucks to determine which nozzle is in the lowest position and therefore whic
Electronics Forum | Mon Sep 21 01:57:55 EDT 2009 | kaz
Hello All, My first visit here. I own and operate a small Industrial & Consumer Electronics Service Shop. There is more and more modules with high density fine pitch SMDs that we cannot handle. We bought PACE ThermoFlow BGA SMD station with a bunch o
Electronics Forum | Fri Apr 27 15:03:34 EDT 2007 | cyber_wolf
Rob, .06mm to .1 mm is slicing the bologna pretty thin. Grab ahold of your placement shafts and physically pull back and fourth on them. There should no play. There are also sliders at station 1 and the placing station 11.(I think 11 is place) Make
Electronics Forum | Mon Apr 20 08:09:51 EDT 1998 | Martin Plourde
I have 3 A.P.EChipmaster SMD-1000 rework stations for sale.These are still being sold new. They are in like new condition. I also have 2 Champ SMD-1500 Precision Alignment/Placement Systems for Sale. Chipmaster SMD-1000 $900.00 Sold new for $350
Electronics Forum | Fri Nov 10 09:21:20 EST 2006 | Steve
I had a PDR Lightmaster Pro at the last place I worked at, and I thought it was the best rework station I've ever used. Not only because of the fact that no nozzles were needed, but the heat delivery from the focused IR light was superb. I don't know
Electronics Forum | Thu Jul 08 13:21:18 EDT 1999 | Bob Barr
Ron, We use 100 pin straddle mount connectors on some of our 1.6mm boards (up to eight per board.) They come to us from the vendor with a bead of solder on the somewhat 'J' shaped leads. Our process is as follows: Mount connector to board with hard
Electronics Forum | Thu Jul 31 14:07:44 EDT 2014 | kurtiss
I found a bad solenoid and replaced it solenoid 15 on station 11. The machine is still erroring out. I also checked the holders and sensors and they seem to be ok. This error occurs when ever the machine tries to change nozzle sizes on any holder. T
Electronics Forum | Tue May 14 20:25:02 EDT 2002 | russ
Hello All, I've got a little problem here. I have a 456 ball PBGA 1mm pitch, .5mm balls, with .6mm pads on the board. given that the pad size is way to big (S/B .45mm or so)I need any and all advice on how to rework these things without shorting o
Electronics Forum | Thu Jan 09 18:46:04 EST 2003 | ReworkMAN
The DRS systems are far superior. They don't compete with ERSA or Metcal. The nozzle technology, heaters, and software are so much better. I would find a used DRS22C and use it before those other systems. The vision system in the DRS22 is great