Electronics Forum | Tue Mar 04 16:02:53 EST 2003 | Dave C.
We have auto-correct funtion on our Panasonic Create CM-301 placement machines but have never turned it on because of a perceived loss of placement time when the camera verifies placement. We look at the first article and correct placemnt if needed.
Electronics Forum | Wed Mar 05 03:43:58 EST 2003 | testing
Hi, Mike Thanks for the reply With your oracle system were you able to perfom SPC analysis? and if possible do you have any Material that may be helpful for me to get my system setup i.e. whether through Excel, Access, Oracle etc. + What are your
Electronics Forum | Thu Mar 06 03:46:35 EST 2003 | testing
Thanks for the reply Mike, I will look forward to see the end result of your investigation (e-mail people_1@fsmail.net). Regarding the test machines, I was trying to ask what are the suited/or recommended from your experience, set of test equipment
Electronics Forum | Tue Mar 01 10:31:26 EST 2005 | Greg
QC --> Touch-up --> QC --> Assembly After SMT all PWB goes to QC, QC Inspects and marks all that needs rework then PWB's goes to Touch-up to fix what QC marked for rework. After that All reworked boards goes to QC for another verification and stampi
Electronics Forum | Sun Mar 06 17:39:15 EST 2005 | Darby
1st law of Surface Mount. You WILL run out of parts on the last board going through before a long weekend. 2nd law of Surface Mount. Touchies WILL touch. I'm with Russ and Rob. Touch up is EVIL and should only be tolerated in exceptional circumst
Electronics Forum | Mon Jul 18 18:36:01 EDT 2005 | slthomas
"thomas, why isn't it process control," Minute detail, really. Defects aren't a measurement of process parameters, they're the result of them (and a few other things that have been mentioned). SPC measures process parameters. It is preemptive, and
Electronics Forum | Tue Mar 04 17:27:07 EST 2003 | msivigny
Hello Dave, I can understand why you might not use the auto-correct function based on the time it takes to perform the operation. I question why there is an auto-correct function in the first place? If I understand the way this works correctly, the m
Electronics Forum | Thu Mar 06 11:37:17 EST 2003 | msivigny
Hello Phil, sorry for the confusion, because of our level of defect control and tracking at each process step, we did not use AOI systems at the time. We had a manual inspection station after reflow, then ICT and Functional/Final test for each produc
Electronics Forum | Thu Mar 03 09:04:26 EST 2005 | russ
Been following this thread and have a question, Why do "touch-up" people follow different criteria than "Q.C." people. It sounds like the root of the problem is not addressed but bandaids are being put into place. We have no "Q.C." department and
Electronics Forum | Sat Dec 16 13:18:47 EST 2006 | Ola
Why not? If You think it has a bussiness case so go for it. We are currently using a firm that has 24h delivery time if neccesary (we need to order before 9'clock in the morning)and we once in a while use this for some prototypes. Their regular shipm