Electronics Forum | Thu Jun 06 18:16:58 EDT 2019 | davef
The nerds say they've fixed the problem. They say the problem was caused by bad, obsolete code. Based on my review, I believe that they corrected the problem. Good job nerds!!! Hopeful, our faith in man [and woman]-kind is restored with this fix.
Electronics Forum | Sat Jun 08 07:23:20 EDT 2019 | bane016
Hello everyone, I have problem with 2d code. Must to improve quality of 2d. Have someone some pdf or manual for this machine? Thank you.
Electronics Forum | Mon Jul 08 11:19:55 EDT 2019 | jwwolf
How can I get past error codes upon startup of a Panasonic BM221? There is a password required and this machine was acquired from an auction. Are there default passwords, or is there a way to reset the machine? Thanks
Electronics Forum | Sun Aug 18 21:06:45 EDT 2019 | dman97
Based on the fuji error codes, It says that the ARCNET cable is disconnected. Make sure that all cables from this module are connected to the QP.
Electronics Forum | Wed Sep 04 12:55:51 EDT 2019 | dwl
Sounds like its just rejecting parts. Either the length and width of the component is wrong or the tolerance is set too tight. I don't remember the function codes to edit the tolerance but I left them at 30% (the max) and never had any problems with
Electronics Forum | Sun Oct 06 06:54:48 EDT 2019 | sarason
And what do you mean by commercial? Chinese hit/run adds for Circuit board manufacturers? A sutble plug after I have answered a users question and have sometimes even written code at my time and expense to solve their problem? Sarason Author of P
Electronics Forum | Fri Jan 10 04:42:14 EST 2020 | richardcargill
SOLVED !! Booting up into DOS there's a file called optedt.exe in the AP folder. This is the option editor. It's password protected when you run it, but a quick look inside the code solved that one. QMPM gets you in if you need it
Electronics Forum | Thu Mar 04 18:39:54 EST 2021 | SMTA-64387124
I have successfully used laser marked bar codes on PCBs. Use an area without any copper so that you are marking on the FR4 only
Electronics Forum | Fri May 07 21:31:52 EDT 2021 | sosigguy
Have you checked WinMCS? it's the software in windows that controls the machine. if you open it up it might have thrown some error codes, i believe it has some diagnostics in it aswell.
Electronics Forum | Tue May 25 05:04:10 EDT 2021 | fujipro
Error codes would be helpful. In most IPS error cases, the Documentation will not help you. For remeasuring the IPS are special Tools needed. You need to send the head to your Fuji Service.
