Electronics Forum | Thu Nov 15 07:59:53 EST 2001 | John S
My company is in the process of evaluating dispensing/screen printing vendors for a new production line that will build a mixed through hole and smt board in high volume. DEK recently came out with a system that uses a thick plastic stecil with mach
Electronics Forum | Mon Nov 19 09:51:51 EST 2001 | MDion
Bonjour, Is there any study done about the effects of X-RAYs (INCLUDING Airports/Customs systems) on electronic assembly ?? We have had few problems with products recently where the programmed flash was not functionnal (corrupted data) when tested
Electronics Forum | Tue Nov 20 04:38:18 EST 2001 | frha
How to implement an easy SPC in the production line? Im looking for relevant characteristics to perform SPC on electronics (e.g. PC-module with motherboard and UPS, power supply's, field bus cards, servo drive systems etc). I understand that compon
Electronics Forum | Thu Nov 22 10:02:42 EST 2001 | Adam
Guys Has anybody had experiences with plastic glue stencils good or bad ? I also have a couple of questions : 1. Can I use the same aperture design rules for plastic stencils as I do on my metal glue stencils ? 2. How repeatable is a plastic glue st
Electronics Forum | Tue Dec 18 12:23:52 EST 2001 | mparker
Dermot - please review a recent thread, titled "Where's the drill?" It was started sometime last month. One of the more prolific posters of this forum had a problem. Many replied with various comments. Your mothballed system is a problem waiting to
Electronics Forum | Tue Jan 08 14:54:10 EST 2002 | Yannick
Hi, I experience some trouble with my solder joint recently. And I'm wondering if someone could help me with this. First I use a thermocouple wich I must tape to the board to profile my temperature. I want to buy the Temprobe from Saunder Tech
Electronics Forum | Wed Jan 16 15:23:11 EST 2002 | dougt
You sound like your set to go with MyData. If you still have some time look at what Contact Systems has. Their older machines were slower compared to what is out there but they are awesome prototype machines (write a quick program, run a couple of
Electronics Forum | Wed Feb 27 10:35:25 EST 2002 | dougt
This is just a general question. I'm no vacuum expert and I'm curious how pick and place equipment manufacturers are able to turn off and purge their vacuum systems and sense this so fast when they are placing a part on a board. Are they turning it
Electronics Forum | Fri Mar 01 04:42:13 EST 2002 | wbu
Hi Nightbull, here�s daybull speaking. Yes the same question for me, what kind of auditor was that ? What I do in an similar audit situation is simply pointing to, if existing, an obvious lack of performance in certain processes depending on my humb
Electronics Forum | Tue Mar 12 10:12:51 EST 2002 | steve_arneson
Wolfgang, I agree with your training concept. The idea that you need to look very closely at what type of equipment to choose is also very important. The key point is not to eliminate any of the options available based upon one view versus another
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400