Electronics Forum | Sun Jul 23 18:28:59 EDT 2006 | mika
Please be a little bit more specific about your problem. 1. is it all components on every board? 2. is it only components placed from one machine in the line? 3. is the solder paste registration ok? 4. is this a new product, that have never been runn
Electronics Forum | Fri Aug 04 16:11:59 EDT 2006 | chrisgriffin
Hell Doc, This is an easy one. But first I must disagree with the wave master. I have done extensive refurb. jobs on Soltec and Vectra. The only thing Soltec has on Vectra is a better solder pot, and even that is close. Vectra software is many, m
Electronics Forum | Wed Aug 09 08:46:48 EDT 2006 | pavel_murtishev
Good afternoon, Take my word, bent THT leads will surely cause problems with manual/automatic component insertion, and surely will create voids in solder joints. As a rule, PIH components are placed by hand and good PIH THT manual component placemen
Electronics Forum | Wed Aug 16 03:48:24 EDT 2006 | umar
Hi All SMT Net Team Member, I always have problem at MY SMT process and production side, Every time product running at my production side always found a lot solder Ball issue near the pad of SMT chip component. We had quite hard to do the trouble s
Electronics Forum | Thu Aug 24 19:26:07 EDT 2006 | darby
Dave, Cygnal was taken over by Silabs. I based my design on the second link that you provided. Tell me folks, are you using one large pad with only the stencil having the grid, or are you actually breaking up the large pad into grids with mask around
Electronics Forum | Tue Aug 29 08:11:12 EDT 2006 | davef
"... we've coerced Josh into driving us out to Watson's bay, braving the horrendous parking situation, to visit Doyle's." Good for you, but you could be parking on a sinkhole: http://www.uwsp.edu/geo/faculty/ozsvath/images/winter_park_sinkhole.htm
Electronics Forum | Thu Sep 14 05:11:29 EDT 2006 | ?
All, We are a contract manuf. for electronics. Since changeover to RoHS we still have customers due to one thing or the other telling us to run Non-RoHS. They are not exempt. What do we do ? do we tell them that we are not running their boards and
Electronics Forum | Fri Sep 15 15:51:53 EDT 2006 | MFG CAVEMAN
We have a new product that uses an SMT edge connector. The process we are using is as follows: -Screen print side 1 (no paste on connector pads) -Place Rs & Cs -Reflow -Screen print side 2 (paste on connector pads) -Slide connector into side 2 wet
Electronics Forum | Tue Oct 10 16:04:45 EDT 2006 | slthomas
*and* board repair, does anyone know where I can get (optimum resolution) an economical repair on an ICOS MVS 100/32 vision card, or (next best thing) a schematic for it? Tyco can't provide a schematic because they don't have one (proprietary techno
Electronics Forum | Tue Oct 24 15:46:09 EDT 2006 | aj
Mark, The pcb manufacturer recommended we bake the boards , so we did. I even weighed a batch before and after and seen slight decrease possibly 0.1g in weight. However we still seen some delam after all this. I am confident our issue has nothing to
