Electronics Forum | Tue Feb 12 08:42:56 EST 2013 | bobpan
I hope you realize that you can pocket position the part so that it is in the center of the beam on the feeder. To do this.... 1. press both buttons (light go out) 2. press rear button 3 times 3. Then use front button to position part 4. The press re
Electronics Forum | Tue Feb 12 17:28:37 EST 2013 | davef
I'd write a Corrective Action Request on every single thing that wasn't the way I thought it should be. Highlight the problems that you see, maybe someone else will agree with you. * When you're declining, no one wants more things to fix, because eve
Electronics Forum | Thu Feb 14 13:10:58 EST 2013 | markhoch
I had this problem once a loooooooong time ago with a 248 that was at my previous place of employment. If I remember correctly, my issue was caused by a set screw on the drive gear that had worked itself loose. My issue was stright forward and quickl
Electronics Forum | Fri Feb 15 13:45:18 EST 2013 | cowens
We have a MPM UP2000. We are getting a hardware limit error when we turn the machine on and try to reset. The F14 fuse blows every time we replace it. The downstop is the first axis that it tries to go through but we get this error. Any help would be
Electronics Forum | Fri Mar 15 18:44:34 EDT 2013 | anvil1021
We will try both the solder mask and the .001" Kapton and see where we end up with each. This is a fine pitch dual row QFN and we cannot afford too much paste on the .004" stencil we are using. We have experienced shorting in the past with .005" sten
Electronics Forum | Fri May 24 09:16:36 EDT 2013 | grahamcooper22
you need to reduce your time above liquidus to as low as you can...maybe 10~30 secs to allow the solder to wet to the gold but minimise the amount of gold that is dissolved into the solder joint...try also reducing the peak temp to 200~210 deg C. Thi
Electronics Forum | Tue May 07 16:02:09 EDT 2013 | ngineer
That's good info for making sure the motor is good before plugging in and possibly over-current another stepper drive. Do you happen to have pin-outs for the DB15 on the drive board, pot settings and current limit of this drive? We keep several ste
Electronics Forum | Tue May 07 13:42:45 EDT 2013 | tanderson
These are dropped/mis-placed by the machines. We have older Quad QSP-2's. My concern is it's easy for the operators to overlook the dropped parts, keep running the job and when they're done, throw away parts (inexpensive resistors aren't such an issu
Electronics Forum | Tue May 07 16:36:04 EDT 2013 | shankar2013
Actually thinking of LX14, but for now I need to solve this problem. We have replaced centering jaws, the steel belts for regular maintenance. I don't think there is anything binding. The strangest thing is every time it shuts down it is right at the
Electronics Forum | Mon May 20 15:19:50 EDT 2013 | smtventasmex
i been trying to do that with a lot of my customers but they can not clean that well it works for just one time but you have to remember than this parts are platic, and will have some damages, i can sell to you quality nozzles at the best price on th
