Electronics Forum | Fri Jan 02 13:31:42 EST 2004 | equipsearch
I am hoping that someone can help with this. Am attempting to source "used"/refurb 130kv Hamamatsu x-ray tube and controller (for a CR Tech machine). Am having difficulties in locating a source. If anyone has any ideas, it would be greatly appreci
Electronics Forum | Tue Jan 06 11:47:59 EST 2004 | equipsearch
TL IPS: I am having problems replying to you directly. Here is the info on the X-ray machine in question. We definitely need to replace the tube and controller. We are not "hell bent" on a Hamamatsu replacement. If you have something else availa
Electronics Forum | Tue Jan 20 17:48:45 EST 2004 | Brian W.
Photon Dynamics is out of the X-Ray business. Try Yestech. They have a number of former CRT and Photon people. Had a similar problem with a CRT 2000 one time. You have to replace both the tube and controller. If I remember correctly, they are m
Electronics Forum | Mon Jun 28 09:56:03 EDT 2004 | John S
Our company is transitioning to TS16949 this year from QS9000. We've begun to wrestle with the subject of improving the control of our production machine programs without creating unneccessary signoff's/documentation. Does anyone have a suggestions
Electronics Forum | Thu May 26 07:07:26 EDT 2005 | ajaydoshi
We do have line configuration. EKRA E4, GL2, CP643, IP3, AOI 7550, BTUparagon150. What are the SPC tools used for SMD process control. I am looking for customized SPC software for trial to do process control on pre reflow, post reflow etc. any info ,
Electronics Forum | Thu Jun 30 18:28:47 EDT 2005 | KEN
1. Migrate to horse-shoe pad design. 2. Verify your furnace is level. 3. Verify your chains are not jerking around. 4. Speed control for fans / gas amplifiers are correct or normal? 5. (this happended to me once) Make sure you don't have any f
Electronics Forum | Fri Jul 01 10:54:25 EDT 2005 | vikkaraja
I had similar issue with our new 1809 Heller Oven recently. It was blowing off some of the lighter parts. I tried kitchen exhaust fan mesh screen (you can pick this up at your local hardware store). Once I knew it was air flow issue, I played with b
Electronics Forum | Thu Sep 22 06:12:05 EDT 2005 | gavinscott
Hi All, I have been tasked with a project on the control of moisture sensitive devices and I was hoping to get some input from the experts out there... How do you monitor total exposure time for a MSD? If the packaging has been opened and re-sealed a
Electronics Forum | Mon Oct 03 09:19:10 EDT 2005 | John S.
We've been using Horizon 01's for a couple of years. We use the advanced 2d board and stencil to setup process control through QC-Calc. It works very well, but you must put the time into setting it up. Ask DEK if they can get you a manual for thei
Electronics Forum | Sun Oct 09 08:15:12 EDT 2005 | davef
Properly grounding employees and work surfaces is the single most effective method of reducing esd damage to parts. Tell us about your ESD control program and how well it conforms to ANSI/ESD S20.20-1999, Electrostatic Discharge Control Program Stan