Electronics Forum | Tue Jan 30 14:18:22 EST 2024 | spoiltforchoice
It might be worth mentioning that Speedprint (now Europlacer) printers also have a calibrate using your own board capability. They arguably also target higher mix environments given that is the market the pick and place machine targets. DEK uses a v
Electronics Forum | Fri Feb 02 13:08:41 EST 2024 | jdengler
Since you are new to the industry the more important choice is who will support the machine. If you are buying used you will most likely need to "register" the equipment (pay money) to the OEM if you need support. It is most likely that you will ne
Electronics Forum | Mon Feb 19 20:43:57 EST 2024 | erici
Thanks again for the reply. I did what you mentioned on your previous message. When i rebooted the machine i came up with a "software booting" message and didn't go past that. I checked the MC and i got the error "no SRBS, system halted". What is S
Electronics Forum | Thu Feb 29 02:24:55 EST 2024 | redspare1
Strange error, I have looked at the schematic and checked all of the e-stop switches and they're good. The machine isn't connected to anything, but air and power. Has anyone else seen anything like this? 1. When pressing the active button it beeps
Electronics Forum | Wed Mar 13 13:08:31 EDT 2024 | lambert
Section 8 in the J-STD-001 was the initial place to start with cleaning and the requirements, however with all the changes going on within the industry with increase product densities and such, a revision is being created to help understand the need
Electronics Forum | Thu Apr 18 17:47:42 EDT 2024 | dwl
Is your stencil worn out? If your once flat stencil is now wavey, you will be depositing more paste. Ideally, you'll have historic SPI data to compare known good volumes from past prints to the current. Another possibility is moisture. Bake your boa
Electronics Forum | Tue Oct 10 20:14:01 EDT 2000 | Dason C
Hi! CJ. Please advise what is your pitch size ie 15.7 mil or what is your capabiliy can you build the board with pitch 15.75 mil (please note that the actual dimension of the package is 0.4mm), and how many lead on the package. The pad width of Ind
Electronics Forum | Mon Aug 07 14:02:54 EDT 2000 | Brian W.
If you are satisfied with the apertures, then you need to check placement pressure, plant humidity, and the reflow profile. If the placement pressure is too great, it will separate minute portions of the solder from the pad. When the solder reflo
Electronics Forum | Tue Apr 11 20:26:16 EDT 2000 | Dave F
Jeremy: Parts assembler make leads of either Alloy 42 (Invar, whatever) or copper. The solderability of these leads are protected with eutectic or non-eutectic tin/lead solder, palladium or some palladium alloy, or gold. Cuppla things to consider:
Electronics Forum | Sat Mar 18 07:22:37 EST 2000 | davef
Cartman: Ah, another "hidden cost" of no-clean. I love no-clean people they're putting themselves out-of-business and they don't even realize it, but at least they're saving money. Enough pontificating, "yes" to all of the above. 1 Yes, no-cleans