Electronics Forum | Mon Apr 29 05:25:13 EDT 2002 | ianchan
Hi, we do Sn plated I/O pinning insertion into Ni/Au thru' holes. no problems here so far, as we cater for the "interference" (fit-allowances) of the I/O pin into the thru' diameter, via improved PCB thru' hole designs. before this cater/considerati
Electronics Forum | Mon May 20 10:49:12 EDT 2002 | geoff_goring
Are we saying then that IMC can occur at the solder / Cu pad join on the PCB when finished assembled? In our case we are being told that this process is starting before assembly. Is it fundamentally the same thing. i.e. will the Tin diffuse with th
Electronics Forum | Mon May 06 02:30:25 EDT 2002 | dszeto
We have continual vision process error 1CB02003 on narrow view camera during nozzle centering measurement. The wide view camera works properly. So far we have done the following things to rectify the problem but the problem still exists: 1. Replac
Electronics Forum | Thu May 09 17:21:39 EDT 2002 | davef
In describing a bare board, you need to talk about base, laminate, and conductive materials. Common laminate materials are: * Glass fabric * Cotton fabric * Paper Common NEMA grades of technical laminates are: * Glass Fabric Grades: G3, G7, G10,
Electronics Forum | Fri May 31 10:35:46 EDT 2002 | dason_c
I think that the IPC spec only apply to the MSD. I had a paper from Lucent and forwarded by Francois Monette, please aware that the first 2 hours, the moisture doesn't bake out from the assembly/component and result show that it is increase the weigh
Electronics Forum | Tue May 21 00:24:34 EDT 2002 | ianchan
yngwie, Hi mate, and Holy Crap! what a blooming pile of 7 feet dung you have sitting on your front lawn! ok, we had a customer SQE like that before, fortunately she was promoted from SQE to purchasing officer. and in the name of universal sharing,
Electronics Forum | Sun Jun 02 02:46:27 EDT 2002 | mjabure
Just a couple of points in response. For the most part I agree with your point on technology transfer, unfortunately the US has been doing this for years. As for who would want these older machines and how could you make a profit off of them. There
Electronics Forum | Wed Jun 05 17:13:58 EDT 2002 | Yannick
Hello! I have a strage problem, we made some production with uBGA, BGA, 0201, 0805, and other type of component. We didn't put the uBGA and 0201 and BGA on the board at the end of the line we look a our solder joint and surprise the solder made a
Electronics Forum | Thu Jun 06 21:35:22 EDT 2002 | ianchan
Hi mates, 1) Firstly, thanks for everyone's reply to this thread. Cheers! 2) Secondly, Hussman69: sure u dun mean that blokes' tie was too tight? musta cut off his blood flow and oxygen?!? 3) Thirdly, we checked with our paste supplier, and they r
Electronics Forum | Mon Jul 01 21:25:14 EDT 2002 | jersbo
Have... Topaz and Emerald X inline (GEM series) very satisfied with thru-put and quality.. as well as tech support... have worked with other machines as well Fuji(3,4) Universal GSM series... and Europlacer(Multitronic) Best software goes to Univers