Electronics Forum | Thu Jun 30 12:21:33 EDT 2022 | kumarb
Thanks. Yes, we have attempted to use standard ROHS profiles in the past and turned our THT connectors into 'chucky dolls' after the PCBA left the oven. We then realized that we need the high temp nylon connectors to allow for the use inside the SMT
Electronics Forum | Thu Oct 12 21:45:21 EDT 2023 | daniel_stanphill
This is a very challenging situation indeed. Have you tried contacting the manufacturer of the component? I know of one time in the past we had a reflow issue and contacting the manufacturer actually proved insightful. I have seen claims using Diamon
Electronics Forum | Tue Jul 20 19:09:25 EDT 1999 | JohnW
| | I recently switched from solder paste in 500 gram jars to 500 gram tubes. I did this to try to limit the time the paste is exposed to the room environment. But we have a need to clean the stencil every 4 - 5 boards which means taking the bulk pas
Electronics Forum | Wed Jul 21 10:05:22 EDT 1999 | Mark Quealy
| | | I recently switched from solder paste in 500 gram jars to 500 gram tubes. I did this to try to limit the time the paste is exposed to the room environment. But we have a need to clean the stencil every 4 - 5 boards which means taking the bulk p
Electronics Forum | Thu Aug 24 10:34:05 EDT 2006 | Loco
We use tacky flux, we just make sure the left over solder on the board is really flat, it kinda replaces paste, although there's probably less solder left then there would be paste.
Electronics Forum | Mon Dec 04 11:46:41 EST 2006 | samir
SMTNetters, I have a product coming down the pipeline that we'd like to make pure double sided reflow, it'll be RoHS product, and the hope is... we'll be able to solder the thru-hole stuff by screen printing solder paste and reflow soldering. Anybo
Electronics Forum | Mon Oct 23 06:51:36 EDT 2000 | fastech6
I have a problem with solder getting into exposed gold pads. What is the best rework procedure for removing the solder and restoring the gold condition of the pad? At the moment, we are also covering the gold pad with kapton tape prior to solder
Electronics Forum | Mon Apr 26 11:42:29 EDT 1999 | Chrys Shea
| | Hi, | | Im doing some experiments and studies on lead free solders ( any alloys).I would like to get some information on a few lead free solder paste manufacturers and if possible their web page adress and contacts. | | Thanx in anticipation |
Electronics Forum | Tue Jan 20 06:38:06 EST 1998 | Igmar
Is there anyone who can tell me what is the maximum allowable soldering temperature when soldering a TQFP (Thin Quad Flat Pack) device in a reflow oven? We recently used a CY7C375i in a TQFP160 package and we experienced warping (bending) of this com
Electronics Forum | Tue Mar 30 08:11:42 EST 2004 | steveliu
Hi, Has anyone here get some experience with SMT connector soldering? We were having really hard time to solder this AMP 50/50 Grid connector. Every connector installed has a few pins just sit on the solder. We use AIM 293DX2B NC solder paste, 60
