Electronics Forum | Tue Mar 30 06:27:22 EDT 2010 | ristikas
It happens on the middle of the stecil cleaning. The camera and the cleaner will stay under stencil in half way back. Then machine asking the initate the motors. If to press initate then the pcb stopper will hit the rails. Usually we move camera and
Electronics Forum | Wed May 11 15:04:16 EDT 2011 | thejedeye
LED sticking in nozzles are such a problem, seem everyone has issues with this from time to time. Don't want to advertise who's nozzles worked best but will answer you back if you drop me an email.
Electronics Forum | Mon Apr 05 21:46:12 EDT 2010 | isd_jwendell
I have been using this series with AIM SnPb no-clean paste without problems.
Electronics Forum | Sat Apr 10 08:17:21 EDT 2010 | nagesh
Dear All, I have a problem with the BTU-paragon -150 reflow oven,with the heaters getting off with Overtemperature Alaram. But the actual temperature on board not exceeding the 255 peak temp. Pls. advice & thx in advance for your sincere postings. R
Electronics Forum | Mon Apr 12 09:13:45 EDT 2010 | toddl
Check your "over temperature module" for both top and bottom zones when the alarm is active, there is a bank of LED's on the bottom of this module. Monitor it to find out if the same zone keeps activating the alarm, if so check your TC for that zone.
Electronics Forum | Mon Apr 19 12:37:49 EDT 2010 | shawnvike
Thanks, that is the problem that I have with my current oven. I do not want to struggle with the same issue again! Shawn
Electronics Forum | Sun May 02 14:37:06 EDT 2010 | dekhead
Something is surging on the 5V line tripping overcurrent on PSU2... If you've got autoflex on the machine the Y15 is th most likely culprit... I've also seen it with the Y2. www.dekhead.com
Electronics Forum | Thu May 13 01:27:01 EDT 2010 | cobar
The problems that could be introduced by attempting to transfer paste into alternate containers far outweighs the penalty of wastage of paste.My grandmother doesnt receive a rebate from the filling stations because she only travels 50 miles a month w
Electronics Forum | Fri May 21 15:36:05 EDT 2010 | ccross
That is exactly the type of problem we are having. Some work, some dont. We feel these parts are not counterfeit so to speak but reworked, removed from other boards, cleaned up to some degree - hence the flux residue, black contamination, scrapes, wr
Electronics Forum | Fri May 21 07:44:28 EDT 2010 | mun4o
hi, I have similar problem 2 year ago.BGA256 , hole in pad technology.I order PCB manifacturer to fill hole with solder mask.And now everything is ok. regards