Electronics Forum | Wed May 19 17:54:41 EDT 2010 | gregcr
I have had problems corrected by swapping or replacing the power supplies in the box. Do you have a second GSM that runs the AIS3500 box? If so swap the power supply and see if the problem follows the swap. I have replaced the supplies inside the
Electronics Forum | Thu May 19 08:52:23 EDT 2011 | unidec
I just discovered this post, I believe we sent you a response to your inquiry. Please call 888-701-0038 or visit our unidec website knowledge base to get tips on loading the AIS3500EX. We repair the AIS3500EX vision systems at a reasonable cost.
Electronics Forum | Tue May 11 10:58:51 EDT 2010 | davef
Paste for dispensing differs significantly from paste for printing. [B Toleno Henkel Loctite]. So, if you compare paste characteristics: Characteristic of paste||Printable ||Dispensable Viscosity [million centipoise]||0.8 to 1||0.2 to 0.4 Metal cont
Electronics Forum | Tue May 11 14:17:55 EDT 2010 | isd_jwendell
Getting the paste from the jar and into the cartridge without entrapping air can be difficult. Can you not just transfer the 500g jar into smaller working jars? This way you can keep the bulk of your paste refrigerated until needed. Air is not your f
Electronics Forum | Thu May 13 01:41:31 EDT 2010 | nrw
Thank you everyone, I realise the problems now and the whole exercise might not be worth the money saved, versus just throwing out the leftover paste. I am based in Australia, so the number of players in this market is small and they know it. The pr
Electronics Forum | Sat May 15 11:27:26 EDT 2010 | davef
We'd expect both OSP poor wetting and improper reflow recipe to show-up in more places than just this one component. But if those are the only choices, we'll go for 'wrong solder paste.' Ooops, that's not one of the choices. Ok, OK, we'll take poo
Electronics Forum | Fri May 14 12:44:26 EDT 2010 | padawanlinuxero
Hi Since we are a small company with a small smt line, we did not have problems with our stencils because they are small and could clean them with Alcohol and wipes, but now we are growing, and now I am having a 20X20 stencils frames to deal with,
Electronics Forum | Mon May 17 12:46:43 EDT 2010 | flipit
Big problem. Certain LED from certain manufacturer sticks to the tape and reel cover tape. Peel back the cover tape and every LED lifts out of the embossed pocket and sticks to the cover tape. I believe this is from static and not any sort of adhe
Electronics Forum | Tue May 18 11:22:24 EDT 2010 | flipit
The ionizer was something we thought about right away. I need to investigate further. Somehow I need to get the ionizer mounted on the chipshooter. An oldschool chipshooter. A turret machine. My other concern is can I blow the ionizer at the par
Electronics Forum | Tue May 18 12:41:28 EDT 2010 | scombs
We have seen the same thing on small parts (8mm tape) and what we did is sprayed some ESD mat cleaner on a lint free towel and wiped the cover and carrier tape down. Since the cleaner is static dissipative the issue went away and we were able to get