Electronics Forum | Thu Oct 09 22:57:10 EDT 2008 | dphilbrick
Customer Specification, parts must be certified to have no less than 3% lead content on the lead prior to attach! It's a Hi Rel Mil Spec FAR Clause in the RFQ.
Electronics Forum | Mon Oct 20 17:38:20 EDT 2008 | davef
We hate to throw soft pitches, but here goes ... What are the specifications [eg, resolution, magnification, etc] for digital microscopes for: * Routine inspection * Failure analysis
Electronics Forum | Mon Oct 20 15:24:52 EDT 2008 | davef
During reflow soldering, sometimes via fill with solder leaving the solder connection starved. Questions are: * Specifically, what is the problem you see? * Do the defective pads show that solder has melted in a uniform fashion? * How do the tempera
Electronics Forum | Wed Oct 29 03:39:31 EDT 2008 | milas
Thanks for the feedback dave. What kind of problems am I liely to face if I was to stick it out with my current specification ?
Electronics Forum | Tue Nov 04 15:53:04 EST 2008 | mikesewell
Not specifically changeover software...but it will compare and highlight the differences between .xls files. Good for evaluating new ECOs from customers. http://www.grigsoft.com/wincmp3.htm
Electronics Forum | Wed Nov 05 13:34:24 EST 2008 | ed_faranda
Exactly what should I look at in my reflow profile? Soak Times, TAL, Peek?!? I am right in the middle of the manufacturing specifications as far as my profile goes.
Electronics Forum | Wed Nov 12 09:39:11 EST 2008 | markhoch
Thanks Dave! I'm fighting the very same battle. Specifications are sparse on the subject, but you offer a very viable solution. (As usual!)
Electronics Forum | Wed Dec 03 16:39:49 EST 2008 | bandjwet
Hi All: Does anyone know how to specify or buy 1oz copper foil in a sheet format? Thanks BWET
Electronics Forum | Wed Dec 10 21:30:59 EST 2008 | davef
We've never involved ourselves in this specific type of effort, but in the past, when removing conformal coat material the supplier of the conformal coat mat material was by-far the most knowledgeable about proven techniques for removing their materi
Electronics Forum | Sat Dec 27 12:30:40 EST 2008 | dmeister
Hi, Does anyone know how to determine the adhesive force of solder paste - specifically the ability of the paste to hold a component in place as it moves down the conveyors on an SMT line. Thanks, DM