Electronics Forum | Tue Mar 19 13:02:49 EDT 2013 | caurbach
We've used masking tape and peelable (pink) mask to mask our boards before conformal coating for a long, long time. This is a huge time sink, and increases our lead times (particularly because of the cure time for the pink mask). What are other com
Electronics Forum | Tue Mar 19 17:17:25 EDT 2013 | technitelec
Hello to everybody i am looking for someone that can tell me how to bypass one faulty module on Fuji NXT machine, i have one module that is always in Emergency stop i think that the problem is coming from a bad cable and i need to keep ru
Electronics Forum | Wed Mar 20 14:21:28 EDT 2013 | jeffharley
Hello All, I am wondering if anyone has come up with an easy and safe way to drain a solder pot on a wave solder machine? We are getting rid of an old machine and replaceing it with an newer machine and we want to use as much of the solder from the o
Electronics Forum | Fri Sep 20 14:06:27 EDT 2013 | jorge_quijano
We were doing the same a few months ago, it took us 1 shift with 2 persons to drain it (we were repairing a leak), we were disconecting the resistors once they were not in contact with molten solder to prevent overheating... Here you have a pic of t
Electronics Forum | Fri Mar 22 10:40:51 EDT 2013 | derekj
Hello all. I was hoping that maybe someone has a manual for a Omniflo 5. Build year is 1998. Photocopies would be greatly appreciated, and willing to pay. Even if we could put down a deposit, you send the manual we do the photocopy and we can send it
Electronics Forum | Mon Mar 25 19:44:32 EDT 2013 | hegemon
IIRC - After completing the reflow, you'll need a soak in DI water for a few minutes (be patient), then peel with a tweezer, and finally use a soft brush to remove the extra bits. At least it used to work that way with the Winslow/Solderquik product.
Electronics Forum | Fri Mar 22 18:16:44 EDT 2013 | vpham
We are trying to use this high-temp solder paste due to a very special process, but we run into tombstones on chip caps, 0402 and 0603. We don't have this problem if we use regular SAC305 solder paste. If you have experience with this type of solde
Electronics Forum | Thu Apr 11 11:06:27 EDT 2013 | ericrr
1) I think maybe not, however having said that, our conveyor does not work between the final placement machine and the oven, in the early days before I became a "experienced" operator in pulling the board out of machine running it along the track to
Electronics Forum | Wed Apr 17 08:35:17 EDT 2013 | emeto
I currently run Siemens and they have their own recommendations about placement force. Most of the passive parts will be placed using 2N. For some BGA'a we will go about 4N and for certain parts that are very easy to break you should go 1N. All parts
Electronics Forum | Sun Mar 24 00:01:44 EDT 2013 | dman97
Does any one have a copy of the GSM programming manual? I have 3 GSM1 machines and am looking to start writing programs for them. I want to replace our aging Fuji CP3 machine. I would appreciate if some one would like to share a copy of said manua
Manufacturer of PCB depaneling and PCB soldering machines since 2005, products include CE approval V-groove PCB depanelizer, PCB router, PCB punching machine, laser depaneling, hot bar soldering machines and soldering robots.
Liwu Industrial Park, Yuanzhou Town, Boluo
Huizhou, China
Phone: +86-138-29839112
.gif)
