Electronics Forum | Thu Jul 30 16:50:41 EDT 2015 | lokit
In our production line we use the pick and placer My100 by Mycronics. We get a lot of feedback from quality department about IC's being placed upside down, wrong polarity. (Wrong polarity usually already delivered to us, or IC's placed in the sticks
Electronics Forum | Wed Aug 19 03:24:49 EDT 2015 | pcbman
I ordered few times of prototyping gold plating > pcb from China. How to i differentiate they are > ENIG or Flash gold? Hi,Friend , this is very easy to distinguish the ENIG and gold plating pcb, you can stratch the solder mask off and see the co
Electronics Forum | Wed Aug 12 11:01:37 EDT 2015 | bnorton
Machine->Config and set all their addresses to 0. We have swapped the EPC5, the VGA Video, the Force board, and most recently the Lantern 630VME. Watching the Force board COMM2 with Logicomm, at the end of all the ldx file processing it changes to c
Electronics Forum | Sun Oct 11 10:00:11 EDT 2015 | brockparry
if you are facing a problem to send the data to your machine then you must check the driver part of your machine if you are sending it through any software. Also check the power status of the machine. You can also go for one simple method by doing Re
Electronics Forum | Tue Aug 04 23:50:20 EDT 2015 | johnwnz
Hi folks, I was wondering what the combined wisdom was on the humidity effect on the MSD control required by the Jedec std. The std works on a relative humidity of 65%, if my RH is only say 30% because of factory environments how do I easily factor
Electronics Forum | Wed Aug 05 12:31:57 EDT 2015 | swiese242
As the industry moves forward it is now optimal and imperative to have this option of inspection. We currently have a used Glenbrook RTX-2500 model that we picked up at an auction and is next on list to replace with a better machine. It works fine fo
Electronics Forum | Fri Aug 14 08:52:34 EDT 2015 | rgduval
Gah! We found the reel empty sensor on the feeders late yesterday. Now, I'm feeling a little dumb after this episode! Apparently, I have a few feeders that have had this "feature" disabled (or that it's broken on), which made it even more di
Electronics Forum | Tue Aug 11 03:27:10 EDT 2015 | iamera
Hello, I am new in this forum and also new in PCB manufacturing. now we have issued about silver open and short. we can detect this defect after auto check process and its to late to save our PCB. Is there any way to detect silver open or insufficien
Electronics Forum | Tue Aug 11 09:48:22 EDT 2015 | samputrah
We have had two jobs that have the same issues with DPAK's sliding off their pads during reflow. We tried to resolve this by placing epoxy on the side of the component to create a "dam". However this is not repeatable enough to be a quality resolutio
Electronics Forum | Thu Aug 13 00:18:28 EDT 2015 | Banana
hi, currently we have Fuji CP8 and XP242 machine for pick and place. as now, most of the customers are going for the 0201 components, so i would like to know does the CP8 has the capability to mount 0201. because, i had run 1 model that has 0201 part