Electronics Forum | Mon Sep 14 08:10:34 EDT 2015 | iamera
Hello Our production face a problem where our board after etching become shrinkage till 0.09mm but sometime it can be till 0.18mm. this happen after etching still the beginning of process not count for silver through hole and carbon process where th
Electronics Forum | Fri Sep 18 05:10:07 EDT 2015 | bobpan
Hello Simon, I would check to make sure the covers are closed and the cover switches are working. Make sure an e-stop is not pressed. After that....I would check the contactors in the rear of the machine. I have had the contacts on the insides of som
Electronics Forum | Wed Sep 16 10:21:14 EDT 2015 | beta
Hi all, Is there much in the way of difference between a Fuji CP6 machine with the CE mark and a machine without the CE Mark? I know why the CE Mark is required within the EU but I am talking nuts & bolts here - is the machine any different? or is
Electronics Forum | Wed Sep 16 14:04:33 EDT 2015 | adventurelights
Hi guys, Recently got an error message when initiating hardware on a Mydata TP9-UFP. Message is: Theta/2: Lower end point not repeatable. Reinitiating fails at message. Haven't seen this message before. Any idea what it could be as production is hal
Electronics Forum | Wed Oct 07 13:41:25 EDT 2015 | 31258
Hello hhel, my name is Marvin and I am an applications/service engineer with Saki America. I would like to know if you are still having a problem with your BF1 frontier. Our office is located in Fremont California. If you are near the area maybe I
Electronics Forum | Tue Sep 22 14:23:42 EDT 2015 | travishemen
We had 4 of these machines several years ago. If I remember right the drive that aligns the board to the stencil was stepper motors with no encoder feedback. We would see the same issue if our leadscrews and linear rails were not clean and properly
Electronics Forum | Wed Sep 30 06:31:07 EDT 2015 | mervin
Thanks SWAG, I have checked the FP mode, I am aware of this. I have also worked on this machine some over 10 years ago but not as a service engineer. So I aware of the programming on the machine its just trouble shooting this particular machine is n
Electronics Forum | Wed Sep 23 00:30:12 EDT 2015 | Wee
Hello All, I am looking for Fuji Flexa v4.6.x English CD ( no need license). Since my computer got corrupted blue screen and CD is gone. I would like to install a fresh program in new computer. Can somebody please share the CD? Thank you so much.
Electronics Forum | Wed Sep 23 07:51:28 EDT 2015 | kkay
We have been experiencing an issue where our Panasonic film caps on a board are losing their rated capacitance. We are well within their recommended reflow specs and no other operation exposes the part to a temp of more than 160°C. The caps will read
Electronics Forum | Wed Sep 23 14:30:05 EDT 2015 | deanm
"...air evacuation is not required (Figure 3-5). Light air evacuation may be used to reduce the packaging bulk and enhance carton packing (Figure 3-6). Full evacuation shall not be used as it will impede desiccant and HIC performance and possibly lea
