Electronics Forum | Thu Nov 19 21:34:09 EST 2015 | ttheis
We just powered up a used GSM1 for the first time and it seems to boot and initalize ok. It is running UPS 3.2.2c. The first thing we noticed upon initial power up is that there is a lot of 'noise' on the monitors. Is this normal due to being designe
Electronics Forum | Sun Nov 22 18:03:38 EST 2015 | ttheis
Hi Deni- Thanks for the reply. I'll try to figure out what vision system is on it. I know it has two 5.3mil cameras front and back, UPS 3.2.2c os/2. Where do I determine the type of vision system; in the computer or harware spec plate?
Electronics Forum | Mon Nov 23 13:46:14 EST 2015 | dilogic
It is written on power-up screen after booting USOS (green letters). I am attaching image of mine, but with newer VME630 vision. If yours shows AIS3500 there, it is probably a problem with video DAC inside that box (located on the machine rear end, a
Electronics Forum | Tue Nov 24 13:37:27 EST 2015 | ttheis
A shot of the screen is attached showing the version information. Where do I find the filters? It looks like the power goes from the switch to the large power distribution box which I presume has the back-up batteries inside. What method is recomme
Electronics Forum | Tue Nov 24 22:18:45 EST 2015 | ttheis
Which card in the VME should I be suspect of? Mine has several modules including EXM-13A, EXM-14 and EXM-9. I found some EXM-13A boards cheap but the EXM-14 is tough to find at a sane price. Am I looking in the right spot? Thank you!
Electronics Forum | Tue Dec 01 23:22:23 EST 2015 | ttheis
Swapped the EXM-13A with no change; going to try the EXM-14 card next. Do the monitors split from one VGA port via a cable splitter? I'm still working on getting manuals for this machine so I'm learning as I go so far, thanks for the help.
Electronics Forum | Mon Nov 23 15:37:49 EST 2015 | davef
Primary ISO clean room standards are: * ISO 14644 Cleanrooms and associated controlled environments * ISO 14698 Cleanrooms and associated controlled environments -- Biocontamination control An introduction to ISO 14644 Cleanrooms and Associated Co
Electronics Forum | Fri Dec 11 19:59:40 EST 2015 | dontfeedphils
What exactly are you looking to verify? Following the manufactures recommended schedule for calibration should be enough. Another option is many AOIs have an option to run a bare board, when doing this it will invert what it's looking for, so every
Electronics Forum | Tue Dec 15 02:00:32 EST 2015 | padawanlinuxero
We do what here is call a master, this board has a bunch of misalign components, missing components, bad solder joints, crack components, and other defects that we want the AOI to look for, now we compare what the AOI finds with a list of the defects
Electronics Forum | Mon Nov 30 02:15:29 EST 2015 | andrei8686
For PCB prototype, I strongly recommend pcbway(http://www.pcbway.com/q I always buy pcbs from them. Buyers have coupons to save cost. The boards are pretty good with high quality. I also appreciate their delivery time. I think about making thousands