Electronics Forum | Tue Dec 31 17:05:20 EST 2019 | slthomas
Assuming you've already looked at optimizing your profile and stencil design, have you looked at metal load in the paste? I hadn't, but just read that increased metal load (associated with reduced powder size, i.e., moving from T3 to T4) has been sh
Electronics Forum | Fri Jan 03 10:32:42 EST 2020 | emeto
Zack, circles 36mil copper 35mil circle stencil aperture. Pitch is 80mil. Stencil is 5mil and apertures are spread 46mm under the 50mm component size. In my mind this might be too much paste. I am afraid that if I print 4mil I might get open joints
Electronics Forum | Sun Jan 05 20:10:16 EST 2020 | sssamw
Yes, you may need tell us how the PCB designed, how it re-flow(even it's Indium voiding formula), how stencil is. The void ratio means area ratio, not diameter ratio, so you need calculate it. If you have high ratio void, show its picture.
Electronics Forum | Fri Jan 10 03:57:37 EST 2020 | jakapratama
Hello, When I calculate based on the data you gave, your stencil aperture area compared to pad area is 94.52%. Your aperture area ratio is 1.76 using 5 mils thickness foil. OK, your stencil and your paste release is not the culprit here. Your proble
Electronics Forum | Wed Jan 01 13:03:06 EST 2020 | ramsus
hello experts i want to calculate my target of cph i have a panasonic line composed of three machines 1.CM602L 4 HEADS 12 SHAFT 2.CM602L 4 HEADS 12 SHAFT 3. CM602L 2 HEADS 8 SHAFT + 2 HEADS 3 SHAFT Best regards
Electronics Forum | Mon Jan 06 16:58:45 EST 2020 | cbeneat
I would recommend quik-tool. Jim Bernhard essentally the inventor of Grid lok left when they went to DEK. Started quik-tool, we use grid-lok in our printers, quik-tool in our Panasonic P&P instead of support pins. Like quik-tool alot more. JBernhard@
Electronics Forum | Mon Jan 06 11:41:52 EST 2020 | robl
JDT http://www.DEKHEAD.com if you are in the USA Adamtech http://www.adamtech.co.uk/contact.asp if you are in Europe There are some good Chinese suppliers, but a lot of Far East cards can be tarnished & with a reduced life due to running in a high h
Electronics Forum | Mon Jan 06 16:19:32 EST 2020 | richardcargill
haven't tried the MINT as it won't let me get that far !! Swapping the Eproms with card 1 and changing the identifier will let it get to the 'Press SYSTEM key' part of the startup though, then it fails on card 1 instead of 0 so I'll give that a try i
Electronics Forum | Mon Jan 06 09:49:36 EST 2020 | andrewpayonk
Hello, I recently purchased a Hotflow 3 oven, using a step up transformer I received with unit, 220v to 480v. Unit turns on but does not heat up. Getting an F02 error saying no convection. I am getting 480v to oven, I also switched the phase still
Electronics Forum | Wed Jan 08 19:16:56 EST 2020 | spoiltforchoice
http://suddendocs.samtec.com/literature/em_tectalk8a_lr.pdf Even so its still a fairly manual process so I guess you really have to want to use this type of connector because its a whole process in itself and I bet the whole family is a special or