Electronics Forum | Fri Dec 16 17:48:43 EST 2022 | kumarb
Hi. May I ask the factory default password used on the Ekra X4 printer for the PCB parameter changes? Believe it is some permutation of '4113' or similar. We had an accident recently with a drunk driver run through our building. In the process, lo
Electronics Forum | Thu Dec 22 15:21:52 EST 2022 | stephendo
I seriously doubt it. I have never heard anyone even ask about that. What failure mode exactly are you looking at? If by chance you have found ceramic capacitors on assemblies that have failed due to cracks, it wasn't because the reel was dropped b
Electronics Forum | Sun Dec 25 09:51:54 EST 2022 | msirifat
Hello, We use OSP-finished PCB. One component (transformer) will be delayed (approximately 4 months) to getting in our hands. We want to partially complete the PCBA (both SMT & MI) in the meantime and later insert the transformer upon arrival thr
Electronics Forum | Thu Dec 29 18:44:36 EST 2022 | compit
Yes, there are two lengths. My MPM UltraPrint 2000 HiE has trays protruding from the machine about 15 cm, I think. I'll check with the company tomorrow to see if there are any numbers in the manual. I have a link to the part saved - maybe check it ou
Electronics Forum | Fri Dec 30 14:47:44 EST 2022 | dwl
To me, it sounds like a bored quality engineer looking for problems where none exist. I will say that the terminal velocity of a falling reel is below the threshold that would cause damage to typical components. Therefor, it is safe to use a reel th
Electronics Forum | Sat Dec 31 00:52:33 EST 2022 | sarason
Next step trace the RS232 cable. Check all output voltages on your power supplys, b oth loaded an d unloaded. Note any differences. Check he impedancesa of your loads ie is your 24 volt load only measuring a few ohms. You may have a short? sarason
Electronics Forum | Tue Jan 03 07:47:44 EST 2023 | richardcargill
No electrical schematic sadly - and there is no sign of a connector under the mounting hole, so I'm guessing that it's never had this function. The actual light tower on it looks remarkably similar to a DEK printer one, so there's a chance that the
Electronics Forum | Tue Jan 03 15:31:51 EST 2023 | griinder
I use a DTF instead of PTF, but one thing I wondered reading this...Which pocket do you designate as "First Pocket" for your tray in your Feeder.db? Could this be affecting the XY position being returned by the machine? For DTF I use upper left. Shou
Electronics Forum | Wed Jan 04 03:03:13 EST 2023 | msirifat
Hello Magyar, the main reason is supply chain disruption due to covid in china. The regular lot transformers failed in IQC, so we ordered a new lot but it's delayed due to covid. Meanwhile, some other components (bare PCB, capacitor) will be out of s
Electronics Forum | Wed Jan 04 03:04:31 EST 2023 | msirifat
Hello Magyar, the main reason is supply chain disruption due to covid in china. The regular lot transformers failed in IQC, so we ordered a new lot but it's delayed due to covid. Meanwhile, some other components (bare PCB, capacitor) will be out of s
Nordson Electronics Solutions makes reliable electronics an everyday reality. Our ASYMTEK, MARCH, and SELECT brands deliver precision fluid dispensing, conformal coating, plasma treatment and selective soldering equipment.
2747 Loker Ave West
Carlsbad, USA
Phone: 18002796835