Electronics Forum | Mon Oct 03 21:02:23 EDT 2016 | rwd
I am doing some rework to my CCA. I then need to conformal coat the board. I'm using Humiseal 1A33 GEL and my jumper wires are teflon coated. I understand the chemical interaction between the 2 products. My question is "Is this an acceptable prac
Electronics Forum | Wed Jan 29 16:14:16 EST 2003 | blnorman
One of the safest ways to dispose of urethane conformal coating waste is to cure it. Once it's cured it no longer is considered a hazardous waste. In the uncured state it is. We have tubes of epoxy adhesives (out of shelf life) that we do the same
Electronics Forum | Tue Jan 27 04:27:59 EST 2004 | loz
Thanks Dave, sounds totally plausible. In answer to Pete B's questions 1. Spot mask IS only being applied to earthing points, top and bottom side. 2. Unsure. Speaking to manufacturer they are telling me it is compatable. However data sheet is vague.
Electronics Forum | Tue Jan 27 10:54:45 EST 2004 | patrickbruneel
I would suggest trying an acrylic peelable mask. In most cases peelable temporary masks are latex materials. Since you use an acrylic conformal coating it makes sense to use a mask with the same make up to avoid incompatabilities. Link to acrylic mas
Electronics Forum | Mon Sep 27 10:45:19 EDT 2004 | JDumont
Morning all, Can anyone recommend a simple low cost method to spray apply conformal coating to our PCB's. Looking for something simple, semi-automatic, and repeatable for operators to use without problems. This is a very low volume application, appro
Electronics Forum | Wed Dec 01 13:47:02 EST 2004 | gs
Wood or Black Light is the common way to call that UV ligth used ie. inside "disco" and used for many applications like to activate the fluorescent particels contained by conformal coating material,adhesives, paper money, etc. Any way ask for TL-08
Electronics Forum | Fri Aug 14 09:40:59 EDT 2015 | jvalverde
Hello, I want to make a simple conformal coating machine, I think in a Cartesian robot with MACH3 software. My questions are about the G-Code for the program (the software to design: % open/close nozzle, the paths (trajectory), import the pcb fi
Electronics Forum | Tue Sep 20 05:21:41 EDT 2016 | abhilash4788
Hi, Currently we are facing bubble formation in conformal coatings in the pcba. Have varied various specs of the conformal coating machine, even during manual application also having the same issue. the material used is silicone conformal coating. N
Electronics Forum | Tue Oct 04 20:31:16 EDT 2016 | davef
IPC-7721, Section 6.1, Jumper Wires, Jumper Wire Selection #5 states: "Recommended wire is solid, insulated, plated copper wire, 22 to 32 AWG with a heat resistant insulation. Wire with tin-lead plating may be restricted due to environmental laws."
Electronics Forum | Wed Mar 04 08:32:45 EST 2020 | stephendo
We bought a conformal coating removal machine AKA a sand blaster at an auction. It is a CCR2000 especially made to be ESD safe. Does anyone have any experience with sandblasting conformal coating? We mostly use humiseal 1A33 and UV40. When we use the