Electronics Forum | Thu Apr 03 17:39:37 EDT 2014 | siddharth
You are correct. Both the machines are "semi-automatic". The program can focus on the part you want to inspect and perform basic inspections like void analysis (BGA, QFP) etc. But you have to manually navigate and look for defects like TH solder fill
Electronics Forum | Thu Apr 03 17:50:53 EDT 2014 | rboguski
We use it almost exclusively in manual mode for PCBA failure analysis. Our main purpose is to find head-in-pillow defects; secondarily incomplete wetting of ball to substrate. In two years of almost continuous use we have only had occasion to use t
Electronics Forum | Mon Jan 12 21:31:26 EST 2015 | warwolf
The closer your inspection the more defects you will find, the more rework you do the possible cost you will add and the potential increase of damage you could do to your products if rework is not up to a machine copyable standard. "Is there any in
Electronics Forum | Wed Jan 27 17:32:51 EST 2016 | billthebuilder
We do High Mix, Low Volume and are looking for the best inline AXI with the criteria of industry-leading automation capabilities. The abilities to program offline, automatic conveyor width adjustment and board alignment are important to us. We want t
Electronics Forum | Tue Aug 18 20:57:15 EDT 2020 | dwl
Specs like beam voltage, current and focal point size are important considerations for image quality and you can spend hours going down the rabbit hole learning about them. Fundamentally, what really matters is if you can get an image clear enough to
Electronics Forum | Tue Dec 27 10:11:50 EST 2005 | pjc
Here's a few mfrs. to look at. http://www.vjelectronix.com/vjebeta/index.asp http://www.glenbrooktech.com/advantage.htm http://www.lixi.com/product_workstation.htm http://www.focalspot.com/ http://www.microfocus-x-ray.com/frameset.php?PageN
Electronics Forum | Wed Feb 05 08:51:13 EST 2014 | emeto
What I think it does is to calibrate the camera. You have your tube on the bottom and your camera on the top. For my machine(Dage) I have to put the board I am going to examine inside and select a point on the board surface. THen I just click on this