Electronics Forum | Wed Jun 27 09:17:43 EDT 2007 | gregf912
I have set the PQ with the CP6 station jigs. It is dialed in to 0.02mm of zero. I also checked station 5.
Electronics Forum | Fri Feb 22 08:23:51 EST 2008 | aj
All, I understand that there is a requirement to upgrade the narrow view camera on the Fuji CP642 to place 0201 components - is this necessary ? Also, 1 - What tape package to they come in ? Can you use 0402 feeders? aj...
Electronics Forum | Sun Jul 11 21:10:27 EDT 2010 | fujiphil
First, check the sensors for 17th and 19th station....tune the sensor amplifier if necessary. Then, check the dogs on the nozzle holders... If the above, items are ok... check the 13th station clutch engagement. Calibrate if necessary... fujiphil
Electronics Forum | Tue Jul 13 10:51:55 EDT 2010 | muarty
Sounds pretty much like the sensors/amplifiers need tuned on your machine. It is a fairly straightforward exercise to do this. The sensors basically look at the back of the chucks to determine which nozzle is in the lowest position and therefore whic
Electronics Forum | Tue Jul 13 21:05:04 EDT 2010 | dman97
Thanks for the replies. Indeed the amplifier needed to be tuned. I have recalibrated it and all is working as it should. Thanks for the advice.
Electronics Forum | Wed Apr 16 16:58:00 EDT 2014 | jimmyboz
My first guess, loose wire or bad cable. Email me and I will send you a checklist.
Electronics Forum | Tue Jul 02 10:37:36 EDT 2019 | dman97
I also forgot to add that if the proper data was not generated by flexa for the CP6, then flexa will not communicate with the machine. You need to flush the proper and resend using flexa for the communications to work correcty. Good luck!
Electronics Forum | Fri Jul 19 11:16:21 EDT 2019 | dman97
And yes if the proper data is not correct it will give you a error message because Flexa cannot communicate with the CP6.
Electronics Forum | Fri Dec 08 18:02:21 EST 2023 | jdengler
Not sure on CP6's but CP2 through CP4 series used jigs. We now have an AIMEXIII and it uses jigs. I would bet that there are jigs for the CP6 series machines.
Electronics Forum | Sat Dec 16 09:43:39 EST 2023 | madisreivik
I know, but actually we have very "deep knowledge" of that machine, probably much deeper than we wanted :) So, if any information about nozzles please share !