Electronics Forum | Fri Oct 15 16:52:52 EDT 2010 | wingding
Fuji IP2: I am having problems with an MTU Cycle Alarm error. There is no such error listed in the IP2 manual or the MTU manual. It sometimes comes up while placing parts on a board or sometimes right after Zero Set. Does anyone know what generates t
Electronics Forum | Tue Mar 09 21:22:59 EST 1999 | Dean
| When a board has loaded into the machine and the fiducials do not line up I have tried to use mark edit to set an offset into the program. I lined up the crosshairs and set the data. For some reason the machine did not accept this info. Does any
Electronics Forum | Thu Mar 03 11:10:20 EST 2005 | Dougs
I'm telling you i've bought the nozzles wound the wrong way and it helped, no more probs with nozzles sticking, i'd tried buying fuji nozzles, checked all my component heights, set Z0 properly, checked shaft heights, set up st1, etc etc but the new s
Electronics Forum | Fri Apr 21 03:20:04 EDT 2006 | kent_peterson
I think your refering to the sleeve. It is held in with loctite 262 or something. You can set up a bearing puller with a socket to pull it out around station 2-3. Fuji will drop the whole gear out to do this. Too much for a few sleeves.
Electronics Forum | Fri Nov 04 13:08:32 EDT 2011 | dwoodbury
Hi. We are having problems with what appears to be the firmware for our QP341 machine. It will not allow us to calibrate or change any settings for the pick-up-point on the tray unit. We are following the procedure in the manuals but it is not workin
Electronics Forum | Tue Apr 01 17:14:11 EDT 2008 | aj
Hi, We only have 2 lines , but I dont allow any of the Ops to set them up, I did once and winded up with 10 damaged nozzles and cracked caps on the boards ... If the problem is as big as you say it is , you should really spend some time setting it
Electronics Forum | Thu Feb 05 19:19:51 EST 2004 | alwil
Thanks for the feedback guys. We have Fuji IP3's, so we can save all the reels and bottom tape too. Stick feeders are a nightmare. Lost production due to the long set up times of vibratory feeders is ridiculous. Also, pick up rate is inconsistant fro
Electronics Forum | Thu Aug 25 09:56:39 EDT 2005 | cyber_wolf
Can anyone tell me what he overall height of a CP6 board support/backup pin is supposed to be? They don't sell the back up pins as an assembly. It looks like you have to buy them piece by piece and set the height yourself. Thanks
Electronics Forum | Tue Jul 22 08:26:03 EDT 2008 | mmjm_1099
I would suggest calling Fuji and they can do a webex with you. But, if you wish to figure it out yourself here you go. 1.) Go into the program you wish to change. 2.) CP43 machine configuration 3.) Pick which holder you wish to change and a drop dow
Electronics Forum | Tue Mar 09 14:29:40 EST 1999 | Jason Hall
When a board has loaded into the machine and the fiducials do not line up I have tried to use mark edit to set an offset into the program. I lined up the crosshairs and set the data. For some reason the machine did not accept this info. Does anyone h