Electronics Forum | Wed May 27 14:35:52 EDT 1998 | Justin Medernach
| | R&D is currently designing a board with smt components on both sides of the board. They are adding a 16 pin IC Gull wing. on the bottom side of the board. I have asked for only caps and resistors to be placed on the bottom side. Is there a recomm
Electronics Forum | Fri Mar 26 17:12:17 EST 2004 | ben
I have recently encountered a new pcb design with a very high density of components on either side of the pcb. One of the suggested "fixes" is to use the smt pads as vias i.e. the via will be drilled thorough the centre of the smt pad. My concern i
Electronics Forum | Mon Oct 15 10:57:32 EDT 2001 | davef
Before this wave solder pallet salesman blather gets too far out-of-control, let�s stop for a minute. The three major approaches you have are: 1 SELECTIVE SOLDERING: Using: * Specialty wave soldering machine to solder specific areas of a board * P
Electronics Forum | Fri Apr 10 10:04:44 EDT 1998 | justin medernach
| I would like to invite everyone to share/discuss | information/knowledge/experience they have with | the req's that are assumed to be valid for the | temperature/time relation in the process of reflow | soldering Pin In Paste, Intrusive Reflow or w
Electronics Forum | Thu Sep 01 10:44:32 EDT 2005 | Clampron
Hi Slaine, Actually, HMP Leaded solder is not complient, it is exempt only when the specific application requires this temp. Sorry for the intrusion but I am working on something very similar currently. Thanks Chris
Electronics Forum | Fri Oct 27 08:24:41 EDT 2023 | avaqsemi
When designing a PCB to accommodate an intrusive reflow narrow profile connector (electrode rectangular) with specific dimensions, you'll need to consider the pad size, hole size, and other factors to ensure proper solderability and mechanical stabil
Electronics Forum | Sun Mar 25 17:02:41 EDT 2007 | johnwnz
Folks, I may be havign a thick day, it is Monday afterall and it has been very sunny over the weekend. We have recently started buildign a fairly high volume of products that is using intrusive reflow on two PTH DIN connectors and havign soem good s
Electronics Forum | Sun Apr 12 12:55:11 EDT 1998 | Bob Willis
| I would like to invite everyone to share/discuss | information/knowledge/experience they have with | the req's that are assumed to be valid for the | temperature/time relation in the process of reflow | soldering Pin In Paste, Intrusive Reflow or w
Electronics Forum | Mon Apr 13 12:11:41 EDT 1998 | Justin Medernach
| | | I would like to invite everyone to share/discuss | | information/knowledge/experience they have with | | the req's that are assumed to be valid for the | | temperature/time relation in the process of reflow | | soldering Pin In Paste, Intrusiv
Electronics Forum | Wed Mar 30 16:28:12 EST 2005 | Guest
Aluminium tape adheres quite well and is not intrusive. I believe it's mentioned in KIC's articles as a good alternative to high-temp solder.
