Electronics Forum | Tue Apr 14 08:13:08 EDT 2009 | kpm135
If you plan on loading offline to get the most out of your machine time every day then they are a must. If you don't care about that and how long your change overs keep the machine down then I guess they don't matter.
Electronics Forum | Tue Apr 14 10:08:31 EDT 2009 | leemeyer
This probably goes without saying but in order to utilize the feeder carts you must have enough feeders to have a job running on the machine, and a job loaded and sitting on the feeder carts. Also the IQ system can only talk to IQ feeders.
Electronics Forum | Wed May 09 08:48:51 EDT 2012 | leemeyer
Try going into the program definition screen and delete the permanent table top. Then shut down and reboot. The permanent table top will be re created upon reboot.
Electronics Forum | Fri Oct 12 10:21:03 EDT 2012 | chox
I am looking for someone to contract to come to our facility to provide training on Philips Topaz and/or Quad QSV-1. We are looking for programming, operation and maintenance training. I would prefer someone local.
Electronics Forum | Sat Feb 15 13:06:00 EST 2014 | bobpan
This is a theta axis head 2 error. Manually spin the head and make sure the bearings are loose and spinning. If not, they may need lubricated or serviced. You can also swap theta amps between the heads to see if you have an amplifier problem. Good L
Electronics Forum | Mon Feb 24 14:32:57 EST 2014 | navworx
Thanks Bobpan, It was the theta amp; swapped it to the other side and that side then failed. It would only do it once the unit ran for about 30 minutes. But when it happened, it stayed broken. Swapped out with a refurb from ppm.
Electronics Forum | Thu Apr 09 07:42:36 EDT 2015 | kevinb
Thanks for the info. We tried the reset button but no luck. The UPS is not powering up. We checked the incoming power and it was good. So we took the UPS out and took off the cover to check for blown fuses. We also checked the reset button and it
Electronics Forum | Thu Apr 09 08:59:43 EDT 2015 | bobpan
hahahahaaa......glad I can help..... If you ever need me......go to: www.precision-repairs.com You can e-mail me from there. Bob
Electronics Forum | Tue Oct 06 05:55:56 EDT 2015 | bobpan
There are known problems trying to create the boot disk if its the older quad software. Contact me through: www.precision-repairs.com I might be able to help you. Bob
Electronics Forum | Tue Nov 29 08:02:51 EST 2016 | bobpan
There could be a few different parts causing this issue. If you still need help....go to my website and email me.... www.precision-repairs.com Thanks, Bob