Electronics Forum | Thu Feb 26 12:58:21 EST 2015 | daniel_esposito
Hi everyone! I have P&P Quad IVc. The Hand Held Terminal (HHT)says "V idle" intead of "V ENTER CMD", and when it is running, the HHT shows commands lines each one at the same time it is running. One of our technician entered mistakenly, at the HHT,
Electronics Forum | Sun Jul 12 00:44:21 EDT 2015 | yadir
Hi, I just got a Quad IVc and I'm learning to use it, I got manuals and it is up and running on DOS with windows 3.1 but I noticed that it the Autoprogram is missing, Does anybody has a copy that can share. Regards Yadir
Electronics Forum | Wed Dec 20 13:40:53 EST 2023 | bobpan
the glass is to keep dust out. Now that it is off the dust is already in. Leave the glass off and just run it. If you have a problem 6 months down the road then take dry air and blow it out.
Electronics Forum | Mon Apr 25 20:54:25 EDT 2011 | veeckm
Hello, First of all I am new to the forum and surface mount machinery in general. The machine in question has a problem picking parts correcly. The main problem seems to be that the camera and actual head location is out of calibration? If I do a ru
Electronics Forum | Wed Jul 06 09:10:55 EDT 2011 | bobpan
i have seen bad motor cables cause the problem......you can ohm them out to the driver cards or if you have extras....replace them Bob
Electronics Forum | Mon Apr 08 13:09:48 EDT 2013 | microaide
I have set Maximum Sequence Steps Per Program Segment to 450 and Maximum Placements Per Program Segment to 200. I have two Quad IVc machines, with a separate central controller in each one. One machine has a waffle feeder and will have vibratory feed
Electronics Forum | Fri Mar 11 09:28:34 EST 2005 | Micheal
I need help on a Quad IVC. We are having intermitant problems. What happens is it runs and then all of a sudden the Z goes down into the feeder past the limit. I have changed the Z motor, cleared the memory, and also swapped motion controller boards
Electronics Forum | Mon Jul 06 06:51:50 EDT 2009 | leemeyer
Many years ago we purchased a IOmega ZIP drive that would connect to the parallel port of the computer. They have a utility called "guest" that we installed on all of the IVC computers. We were then able to connect the drive to the parallel port and
Electronics Forum | Fri Mar 11 14:04:34 EST 2005 | Micheal
I changed both cables and still the same thing. I have not changed the quad align cable yet. Any other ideas. Also when I do a run pickup 1 it works normal but when I am in run mode forget it, the z-rod now dont even go all the way down.
Electronics Forum | Tue May 07 09:32:39 EDT 2013 | ngineer
Yesterday, my Quad IVc was on, but not running. There was a power fluctuation. I immediately got a motor err #5. I checked all the doors were closed, tried to home / reset the machine, and then turned it off and back on. Neither breaker was trip
