Electronics Forum | Thu Aug 16 07:46:50 EDT 2012 | omur
We have the following problem with our DEK265GS during start-up: Loading Program... Loading Language... Stack Overflow! Any help / pointers would be much appreciated. Omur...
Electronics Forum | Sat Aug 25 08:22:38 EDT 2012 | omur
Thanks for the pointers. I just tried both of your suggestions - but still the "Stack overflow" message is appearing. Any other suggestions ?
Electronics Forum | Fri Jun 02 15:44:42 EDT 2017 | mrk
Thanks DeanM. Are you adding the additional flux to the paste that you are dispensing, or are you ordering it separate from what you normally screen?
Electronics Forum | Tue Aug 08 20:39:29 EDT 2023 | cbeneat
What manufacturer is it? I usually stack the bars in as tight as possible. Especially against the wall of the pot with heaters. While it's heating keep applying slight pressure with a bar of appropriate material, towards the sides to facilitate melti
Electronics Forum | Fri Sep 10 12:09:02 EDT 1999 | Earl Moon
| | | hi, i m college student. i m currently doing my Final year project in PCB drilling. the main task is to design auto feeder which allign the PCB properly in position before drilling take place. the close tolerance becomes a big problem to the pr
Electronics Forum | Sun Sep 12 08:20:04 EDT 1999 | se
| | | | hi, i m college student. i m currently doing my Final year project in PCB drilling. the main task is to design auto feeder which allign the PCB properly in position before drilling take place. the close tolerance becomes a big problem to the
Electronics Forum | Tue May 16 05:45:46 EDT 2000 | Wolfgang Busko
Ashok: Couldn�t find that part in IPC-7711 either. I was just remembering that proposal from that thread mentioned. So you are still in that position I was at that time. Looking into IPC-D-275 (I have to admit that I have only an old issue in my offi
Electronics Forum | Mon Aug 18 13:46:09 EDT 2008 | realchunks
Tolerance stack up has really become an interesting issue with boards coming from China. What has usually been taken for granted has to be looked into with a fine tooth comb. Most board houses of the past would reject this - but China figures "If i
Electronics Forum | Thu Jun 25 22:25:24 EDT 2009 | boardhouse
In the life of this product that you have been doing this process, has the material alway's been IT180 material? One problem with Lead free material is that it is more fragile that standard FR4 Epoxy laminate. And is known to have chipping or fractu
Electronics Forum | Tue May 24 13:18:43 EDT 2011 | leemeyer
We had a Quad 4C that was fitted with a dispensing nozzle. It was perfect for jobs like this. Place the 1st component in the paste, add a dot or 2 of paste to the top of that part and then place the 2nd component on top. I beleive that you may be ta
