Electronics Forum | Thu Feb 25 20:25:16 EST 2010 | dean
Good question, the answer as of right now is yes. Our machine is only able to go down to 0402 parts before the surface tension of the solder begins to cause issues with maintaining the placement position of the part on the nozzle. However, we are dev
Electronics Forum | Fri Feb 19 11:17:29 EST 2010 | kpm135
When I try to load a board in our MPM UP2000 HiE I get the following error "Z axis software limit". The Z axis will move up and down freely, I re-calibrated it and reprogrammed the board and the error continues. Has anyone else run into this issue an
Electronics Forum | Mon Feb 22 10:19:57 EST 2010 | swag
Check/reseat all connections on axis driver card and from driver card to step motor. On older MpM's it is common to get a bad connection on the connector for axis driver power and blow components on your driver board. Reseating these connectors mig
Electronics Forum | Tue Feb 23 16:45:36 EST 2010 | dyoungquist
Davef is right on as usual. We are doing exactly what you do. Some smt with no clean paste then the plate through connectors on our selective solder machine using water soluble flux. We then clean with a ultrasonic water process. We do see the re
Electronics Forum | Thu Feb 25 15:05:17 EST 2010 | flipit
Multiport nozzles will work better if your pickup is not perfect. Has been a while but are the nozzles 08MPF? I used to pick 0402 chips with 08MPF nozzles. These had 5 holes and were black Delrin plastic. I looked at the 0402 using front lighting
Electronics Forum | Wed Mar 03 19:30:37 EST 2010 | dcell_1t
Yes, it is basically: Rate = Time interval/Cycle time I put time interval since you can measure however you want (pc per hour, per day, per quarter hour... it is relative) the most used is Pc/Hour, so the time interval is 1 hour (3600 sec). Lets sa
Electronics Forum | Thu Feb 25 07:37:42 EST 2010 | pcbrown
We are using Humiseal 1B31 and polyester dots for masking. We are spraying this in a Binks sprayer mixed at almost 1:1 with 521 thinner. Whe are seeing the coating creating thin halos around the poly dots as if the dots are "rejecting" the coating. T
Electronics Forum | Mon Mar 08 16:23:05 EST 2010 | mikesewell
I'd think about database structure and programming aspects as well. I'm cleaning up an implementation where the parts were taught as they appeared to the AOI programmer irrespective of the Pick & Place data/libraries. Lots of rotation fixes, parts
Electronics Forum | Mon Mar 01 13:51:43 EST 2010 | cellis
Yes I am a salesguy from Manncorp. I just wanted to get that out first. You might also want to check us out. http://www.manncorp.com We sell dry boxes and all of our units come with multiple turbo dryers and we are also a little cheaper. All of
Electronics Forum | Tue Mar 02 16:49:37 EST 2010 | davef
For a earlier, similar thread posted by an old friend Cal Driscoll ... Classes of BGA inspection machines * GO/No-go Machine specs: 50Kv, limited zoom, perpendicular head, board size. * Low to mid range machine:+75Kv, Angular inspection,zoom,image c
Manufacturer of PCB depaneling and PCB soldering machines since 2005, products include CE approval V-groove PCB depanelizer, PCB router, PCB punching machine, laser depaneling, hot bar soldering machines and soldering robots.
Liwu Industrial Park, Yuanzhou Town, Boluo
Huizhou, China
Phone: +86-138-29839112