Electronics Forum | Mon Jun 03 15:10:48 EDT 2019 | emeto
Page 43 in the datasheet is giving you all detail how the stencil should look like...if this is what you need to do. Page 42-43 shows the geometry of the part and recommended land pattern for the PCB ...if this is what you need.
Electronics Forum | Fri May 24 03:24:14 EDT 2019 | weglimir
Thank you! it is the same on other slots as well, when I removed the board, error was the same, but it appeared instantly after DEK Program was loaded. When it is inserted - this error appears after 10 seconds (approximately) so it seems like somethi
Electronics Forum | Mon Jun 03 13:01:59 EDT 2019 | slthomas
Is there any chance that the boards were mechanically stressed (for instance, installed in a fixture) before, during, or after the testing? I'm just looking for other possible root causes.
Electronics Forum | Mon Jun 10 13:37:03 EDT 2019 | slthomas
How wide is this board? I ask because if it's not terribly wide, you might just be better off attacking the problem with the profile rather than attacking the board conveyor design.
Electronics Forum | Fri Jun 21 03:33:54 EDT 2019 | romford_navy
It’s now working correctly Had to re-load MMI software to get new System Files
Electronics Forum | Thu Jun 27 08:08:03 EDT 2019 | SMTA-John
Would a sealed cabinet injected with nitrogen which has also passed through dessicant provide ideal storage ? ..dry and little oxygen..
Electronics Forum | Wed Jul 03 07:49:35 EDT 2019 | daniel_marquette
Got it. Servo tuning is new to us, so we'll try it. When you propose to swap the Y axis amps, do you refer to the driver that controls the Y motors? Thanks,
Electronics Forum | Tue Jul 16 03:58:40 EDT 2019 | artem
Hello, what is the difference between the TP9-2 and the TP11-UFP? The TP11-UFP is larger, can it do something more than the TP9-2 except placing more components?
Electronics Forum | Fri Aug 09 03:59:35 EDT 2019 | sssamw
Did you check the pin location accuracy before placement? I mean if possible pin was hit or misaligned a little before placement, so the pin cannot inserted in hole then bent. And maybe you need contact your component supplier to study together.
Electronics Forum | Tue Jul 30 03:57:29 EDT 2019 | SMTA-David
Hi, I am looking for software for 2003 model 1707 EXL reflow oven (HC1 controller). I believe latest version for that model is 1.0.6.5.8 (98 Win) or 4.0.2.1 for XP. Thanks
.gif)
