Electronics Forum | Wed Jul 20 17:23:19 EDT 2005 | davef
IPC-2222 - Sectional Design Standard For Printed Board For Organic Printed Boards, Table 9-3 � Plated Through Hole Diameter To Lead Diameter Relationships will give you the standard information you require.
Electronics Forum | Sun Jul 31 18:32:30 EDT 2005 | crishan
Thanks you for the information LUPO, specially with component minimum clearance. I will also check the XY table for movement accuracy. What specific parameters do you check with your SPC charts. Thanks Crishan
Electronics Forum | Tue Aug 02 04:52:16 EDT 2005 | aj
Crishan, You must be seeing an incredible amount of Attrition on this component if this is the case. You should most definitely be able to put in a Pick-up offset either at the machine or in the part data. aj
Electronics Forum | Fri Jul 29 08:50:30 EDT 2005 | bandjwet
For these type of connectors proper underside board heating, a customized nozzle and careful past printing are the keys to reworking properly. Pls contact BEST Inc at http://www.solder.net offline if you need someone to look at these for you. Regar
Electronics Forum | Sun Jul 31 23:28:32 EDT 2005 | saiwong
Fuji will not sell the reel by itself. also, you need to change the tape guide to 0.7 in order to place the 0402. Tape guide cost you almost a hundred bucks. I don't think it is a good idea to modify the feeder.
Electronics Forum | Mon Aug 01 08:38:57 EDT 2005 | kamrant
Joseph, What is the topside temp reading of your board before reaching the pot? Do you have top-heater in your wave machine? It sounds like; you got an insufficient per-heating issue.
Electronics Forum | Tue Aug 02 21:37:21 EDT 2005 | davef
Are we talking: * BGA that you've reballed and want to clean prior to attachment to a circuit board? * BGA that you've attached to a circuit board after correcting something or other? ... and we're talking a water soluble flux or what?
Electronics Forum | Wed Aug 10 14:12:39 EDT 2005 | tommyttr
Stefan, I am surprised that you have made a un-wise purchase. You need to keep your eye out for unreliable suppliers. Sounds like he just wanted your money, not a good business relationship. Tommy
Electronics Forum | Fri Aug 05 10:17:44 EDT 2005 | stefwitt
Thanks to all of you and the power of this forum, I may get refunded ~ $ 30,000 for missing parts and cost of proper refurbishment. I�ll keep you updated.
Electronics Forum | Mon Aug 08 21:34:44 EDT 2005 | davef
Jim Can you be more specific? What's going "yellow / beige" on you? * Laminate * Solder mask * Legend