Electronics Forum | Thu May 22 16:52:39 EDT 2008 | tonyamenson
Indium got back to me with the attached PDF. I always assumed, that in order to avoid thermal shock, there could not be any more than 80 degrees C difference between the solder pot and the pre-heated board. However, it would seem that any thing le
Electronics Forum | Fri May 22 12:42:43 EDT 2015 | deanm
Sr. Tech, you are right in that there is no verification of the profile. We are a Class 3 high mix OEM. We have visual inspection after SMT. We have not seen problems with wetting, grainy solder, cold solder, charred boards, etc. that would indicate
Electronics Forum | Fri May 15 21:39:48 EDT 2015 | jlawson
Reflow.. 1.Rehm (Germany) - Best in Class Best overall process stability heating system ( Alot of makers have started to copy there VX heating arrangement ). COnveyor chains can be a bit more attention in terms of maintenance on rehm , but if foll
Electronics Forum | Tue Mar 28 07:28:25 EST 2006 | Rob C
I would have to disagree on this. My experience is that you should never justify capital expediture based on just the obvious up front costs alone. There is no mention of risk of recall, warranty costs, scrap costs,and so on. Which you may get from a
Electronics Forum | Wed Sep 21 12:30:03 EDT 2005 | Rob
Hi Greg, We've used lots of machines over the years & seen lots of different tape related issues - the main one being snap off of the cover tape, usually due to too much glue, over entusiastic heat seal, or a feeder requiring maintainance. Also the
Electronics Forum | Tue Mar 23 07:35:42 EDT 2010 | jooh
Since I'm new to the forum I probably ask previously answered questions (that I have not found) but I would be grateful if someone could clarify this for me. I'm in R&D at a company where we design low volume (1k-10k) fairly complex PCBAs for our pr
Electronics Forum | Mon Jun 19 09:47:23 EDT 2017 | georgetruitt
You have a lot to think about! What does the flux manufacturer recommend as far as specifics like water temp or pressure? Do they recommend high temp di-water a detergent or saponifier? Do you currently have a cleaning machine, batch cleaner or inl
Electronics Forum | Thu Sep 20 20:07:24 EDT 2007 | davef
As sources for heat resistant gloves, try: * National Safety Apparel * Radnor
Electronics Forum | Sun Apr 25 02:58:58 EDT 1999 | Haim H.
| Hey Ya'll! | | Have any of you ever worked with one of V-Tek's "Economax" tape and reel machines? The biggest thing I'm curious about is the type of cover tape that these machines use. It's something they call P.S.A. (Pressure Sensitive Adhesive)c
Electronics Forum | Wed Jul 07 09:47:41 EDT 1999 | Peter Brant
| | Q #1) Is it more reliable to have the mask tent over the vias or risk getting vias half filled with solder? These are vias with an .020" hole and .040" or .050" pad. WIth regards to this question, and scott's follow up, I have used the "epoxy me