Electronics Forum | Wed Oct 26 03:43:11 EDT 2005 | meritajs
Hi Ken, Thank for your advice We suppose that with home position all is OK and ratio is in interval 40-60%.Y axis offset is not constant 5mm or 10mm but change ratio with working time and may be more than 10mm We think that problem is with Yservo mo
Electronics Forum | Fri May 20 12:14:25 EDT 2016 | strandy89
Im having trouble with and Ekra x5 machine. It works fine when up being run constantly, but if it sits for 10-15 minutes when you try to move the Y table to the front of the machine it makes a loud sound as if the table is hitting/catching on somethi
Electronics Forum | Wed May 08 10:21:05 EDT 2019 | compit
During the start the error "DOWNLOAD VISION ERROR" - instead of "OK" is "NG". - resolved - video card died. But I still have a motor overload error Y1 (L057:CUR.DEV ... Y1 error) - what resistanc
Electronics Forum | Wed Nov 09 05:12:43 EST 2011 | bobpan
Motor error 4 is an error that is caused by the machine not reaching a position in a timely matter. Usually its in the x/y axis but also could be z. If you have cleared the mod codes (function 35 shift 7) the machine should home. Usually this problem
Electronics Forum | Wed May 13 15:57:43 EDT 2020 | azdback
We have been working on an intermittent error on our hydra. And it seems to happen only after several hours of production have passed, it doesn't happen during the first part of the shift. Our hydra goes from working fine for several hrs to making
Electronics Forum | Wed Feb 28 07:30:26 EST 2007 | cyber_wolf
We recently scrapped our TP9-2U because of an issue similar to this. The X-axis would overshoot the pick and place positions. This particular machine(2U)only has 1 X motor. The UFP's and the MY machines have a small fine positioning motor that is on
Electronics Forum | Tue Jan 13 08:08:37 EST 2009 | leemeyer
I am assuming that the card that was changed was the motor driver card. Did they change the card with a known good board or just swap the X and Y cards. If they swapped cards it appears that the card that is now in the X motor slot is bad. Open the a
Electronics Forum | Mon Nov 25 10:57:31 EST 2019 | rgduval
You should be able to see the counts in the service screen for the motors while testing them...that's usually the easiest way to see if they're functioning...at least the encoders. In some of the older systems, the drive motors were all the same, an
Electronics Forum | Wed Feb 08 01:30:02 EST 2017 | nikkilouie
Im having trouble with and Ekra x5 machine. It > works fine when up being run constantly, but if > it sits for 10-15 minutes when you try to move > the Y table to the front of the machine it makes > a loud sound as if the table is hitting/catchin
Electronics Forum | Fri Dec 17 09:49:34 EST 2010 | remullis
Hello to all, I am having problems with the X,Y table initializing. I noticed the Skew motors 17M1 and 17m2 are moving but the table keeps wanting to drive in the left direction standing in front of machine. It will keep trying to drive until it tim
