Electronics Forum | Thu Jul 25 23:21:40 EDT 2013 | dekhead
1000ct encoder is the only one used on DEK Horizon (Typhoon Series); 2 different manufacturers, but interchangeable. http://www.dekhead.com
Electronics Forum | Mon Jun 12 01:44:02 EDT 2017 | bukas
it looks like it has something like rising table to push board against stencil...
Electronics Forum | Tue Apr 29 14:13:52 EDT 2003 | stefwitt
My opinion to hold on to your machines was based on the current market situation. First of all, I don�t believe that a customer with ten boards will go to China for prototype production. Truth is, that the remaining market here is the prototyping mar
Electronics Forum | Fri Apr 15 15:04:02 EDT 2005 | lyrtech
Hi, Sometimes we have the following error: " TABLE BASE NOT GOOD ". In the manual, it says that we have to check the cylinder and other parts around the table. This is not very specific. Can anyone helps us with some hints? Thank you
Electronics Forum | Wed Jun 21 09:23:28 EDT 2006 | rmitchell
problem solved. Some PCB table support pins were jammed down in the table preventing the Z axis from lowering all the way. The intial error mesage was x and y servo, but the real error was the z axis overflow. Rob
Electronics Forum | Tue Feb 28 11:15:20 EST 2006 | billyd
In my last life we had pretty good luck with the Grid-lok system. Just not very good for extremely large boards, or very thin ones. (Tends to push thin ones up and bend them before the table rises. **On DEK printers, mind you) Form-flex was a nightma
Electronics Forum | Wed Oct 23 10:00:13 EDT 2013 | aj
All, I am glad to report that this issue has been resolved at last. Issue with 40VAC contact in the Y4 crate, as the problem was intermittent it was a difficult one to trace/prove. My thanks to DEKHEAD for assistance and Maxem Engineering..... PS
Electronics Forum | Tue Jun 12 20:54:34 EDT 2018 | dekhead
I don't recall a "Heavy Pallet Rails" option in software; I believe you need to change the Remote Board Stop to "Not Fitted" and move the pneumatic and electrical (BSK6)connections to correspond with the camera mounted board stop. Pretty well detaile
Electronics Forum | Tue Feb 20 09:46:08 EST 2018 | dekhead
Somewhat vague on error message; obviously has to do with RS Table travel (making sensors at anticipated time) but need to know timing of error incidents and specific error.
Electronics Forum | Fri Jul 17 19:43:20 EDT 2009 | fujiphil
Have you eliminated the hardware N.G.? Check the connection for the rear door. If the connection are ok, try to bypass the key. short the two wires for the rear door. If the rear door problem is corrected, check the rear door switch physically. Reg