Electronics Forum | Sat Aug 08 23:38:06 EDT 2020 | jmelson
Well, the machine is here, it has some probems that I need to diagnose, and now I ***REALLY*** need the manuals (both maintenance and operations). Two problems. One is that it will only come "ready" (servos powered on) ONE TIME per day! I'm totall
Electronics Forum | Tue Jul 21 14:44:42 EDT 2020 | mcbasol
Dear Evtimov, Thank you for reply. We have decided to buy MS-11 3D due to competitive price and technical service in Turkey. Also, the technical information is quite good. Another reason that we eill buy Panasonic SPG2 Printer, too. Panasonic is solu
Electronics Forum | Thu Jul 16 15:24:14 EDT 2020 | noTIME
I am trying to understand why most manufacturers don't offer mechanical feeders anymore? I find them easier to use, easier to maintain/fix. Most importantly they are A LOT cheaper! Electronic feeders are very expensive especially when you need 100
Electronics Forum | Tue Jul 21 11:42:32 EDT 2020 | charliedci
I have been tasked with finding the equipment necessary to fully automate our TH assembly. Currently about 98% is performed manually on stuff lines with the other 2% using a 30 year old axial inserter. I am asking if anyone else has gone down this pa
Electronics Forum | Wed Jul 22 15:08:29 EDT 2020 | gregp
How about Semi-Auto insertion. Only one type of machine needed to insert virtually any through hole components. The CS-400E was originally manufactured by Contact Systems and now Versatec is offering remanufactured systems...completely rebuilt to t
Electronics Forum | Wed Jul 22 22:19:07 EDT 2020 | kghadiya
Hello Experts, I am using Heller 1707EXL in my shop. From last 2 months I have faced component missing and flying problem. I tried everything to figure out the problem i.e. change solder paste, re-calibrate PnP machine, several oven recipe etc but s
Electronics Forum | Fri Jul 24 17:28:57 EDT 2020 | rsatmech
Hello all, We have a new model running upon analysis I found one challenge while cleaning the send side boards. We have a thru hole in top where it's bottom ends are covered inside the shield. Operator find difficult to clean as it has high chanc
Electronics Forum | Wed Jul 29 21:16:17 EDT 2020 | SMTA-64387706
Hi, I have a PCB that works fine when tested before conformal coating with HumiSeal 1B73. It seems like the CC is causing electrical issues. We brush it on, so it is a bit thick. After curing we are getting QFNs that do not seem to connect well and a
Electronics Forum | Fri Aug 07 13:30:22 EDT 2020 | emeto
ASM machines have great algorithms for BGA and I am positive it will detect missing ball. Still, on your pictures it seems like you are severely starving solder in the locations shown on X-ray. Part seem too small to bend that much in reflow to form
Electronics Forum | Tue Aug 04 14:06:59 EDT 2020 | stephendo
Are you sure it is not a 240V transformer with a center tap? That is how residences are wired. If you use the center tap you get 120V. The other tap to center tap is 120V that is 180 degrees out of phase. So if you use the two outside taps you get 24