Electronics Forum | Sun Sep 16 21:10:40 EDT 2012 | vikings
I did not desire the manuals to learn how to operate the machines, rather I wanted to know technical data such as the proper PSI for the air supply lines.
Electronics Forum | Thu Sep 13 04:49:30 EDT 2012 | hysmt
We are going to start a smt line, but I'm totally new in this line. Currently we have these two choices, any feedback is appreciated.
Electronics Forum | Tue Sep 18 13:07:52 EDT 2012 | mark25y2001
MPAG3 is capable to detect bend pin in up and down form... but i advice to read both machine specs and compare base on your production need for a wise and best machine selection.
Electronics Forum | Tue Sep 18 21:31:13 EDT 2012 | hyng
Both vendor is convinced the machine meet my production need. Since my budget is low, that is why i choose these old machine. Any more feedback is appreciated!! :)
Electronics Forum | Thu Sep 13 18:00:35 EDT 2012 | mark25y2001
possible problem are loading orientation, solder flow cannot reach the pad portion due to trap of the body of the diode... or try to adjust turbulent but observe overflow... because turbulent are penetrate solder to pad and terminal of the diode. ho
Electronics Forum | Fri Sep 14 06:12:41 EDT 2012 | mbnetto
Hi Arturo. Thanks for you reply. The board is being loading so that the wave bath touch the 2 pads at the same time... I increased the chip wave in a maximum accepted level... One more rpm on the pump the wave sill overflow the board... Thanks...
Electronics Forum | Fri Sep 14 06:17:48 EDT 2012 | mbnetto
Hi Melissa, thanks for you reply... I'll increase the placement force on this component so that it touchs better the board pad. Maybe it couldnt help due to stencil aperture. Maybe I'll have to change it. If you have more ideas, please share with m
Electronics Forum | Wed Sep 19 07:19:46 EDT 2012 | mbnetto
Hi Melissa, We mount this component in the bottom side with adhesive epoxy and the solder is done on the wave solder machine. During the wave solder machine, we have the problem as like the picture.. no solder in one of the pads...
Electronics Forum | Fri Sep 21 02:04:58 EDT 2012 | dman97
Still looking for the manuals. I could live with just the feeder calibration manual. Somebody out there has to have one.
Electronics Forum | Sat Sep 15 00:50:45 EDT 2012 | mdang
Do anyone know a good field engineer or Technical Support for FUJI SMT CP42, CP643 in southern California? Thanks, -Michael
