Electronics Forum | Wed Mar 18 07:56:43 EDT 2009 | cyber_wolf
You can calibrate it until you are purple in the face. Job to job and part to part they are just not consistent.They either fail parts or put them on skewed. I have gone back and fourth on this for(10+) years. We have had Fuji look at it and we have
Electronics Forum | Tue Mar 24 09:04:33 EDT 2009 | sachu_70
External CO2 extinguishers certainly help. But requires the alertness of a trained personnel to use the same effectively during a fire. I have also come across a solution wherein the extinguisher is kept always connected to continuously deliver pres
Electronics Forum | Fri Mar 20 01:04:20 EDT 2009 | padawanlinuxero
Guys I need help!!! Today I was cleaning the TM12 feeder and by accident I took out a screw that is on the side in a place that looks... well it looks like a teddy bear, I heard something falling inside of the feeder and now the screw does not thigh
Electronics Forum | Tue Mar 24 17:14:44 EDT 2009 | bas251
In my experience, before my current employment, I have personally seen damage from the water soluable fluxes left under a BGA. In consideration, I have not seen it from an assembly process where the boards are cleaned thoughly, but I have seen it dur
Electronics Forum | Thu Mar 26 11:29:31 EDT 2009 | cyber_wolf
I talked to Mydata service (briefly) 3 times. Halfway through the 3rd call it was suggested to me that we set up a service call. Times being what they are, we are not willing to go that route yet. Thankfully we are not in dire need of this machine ri
Electronics Forum | Wed Apr 15 12:57:37 EDT 2009 | bk
I'm not sure if you fixed your problem yet or not but i'll give you some insight on your problem. The x wagon motor doesn't move cause of the voltage it actually moves when there's current applied to it. The voltage dictates the direction the motor m
Electronics Forum | Wed Apr 15 14:51:52 EDT 2009 | cyber_wolf
The booster was swapped. I found that I have -35 volts across pins 1 and 3 on the XWB.(measured with a scope) When I switch polarity in the software I do not get anything.(no +35V) I noticed that when I try to pulse the small X with the scope hooked
Electronics Forum | Thu Apr 16 13:23:41 EDT 2009 | bk
well by the looks of it you have pretty much replaced just about everything that could cause the problem. The only one i haven't seen is the cable going from the computer box up to the x-wagon boards. Just out of curiosity when you took your motor fr
Electronics Forum | Tue Apr 21 12:48:13 EDT 2009 | bk
ok you verified that the motor was bad. So now i would go back and verify that your voltages are still good on the back of the computer box and on the booster board. If they all check out fine. I would take the mot x board from your working machine a
Electronics Forum | Wed Mar 25 20:00:32 EDT 2009 | davef
We are not sure what you mean by "any type like plastic, aluminum, stainless steel etc?" Binks [(US Corporate Offices), ITW Industrial Finishing, 195 Internationale Blvd., Glendale Heights, IL 60139; 630-237-5000 888-992-4657 http://www.binks.com] m
Nordson Electronics Solutions makes reliable electronics an everyday reality. Our ASYMTEK, MARCH, and SELECT brands deliver precision fluid dispensing, conformal coating, plasma treatment and selective soldering equipment.
2747 Loker Ave West
Carlsbad, CA USA
Phone: 18002796835
