Electronics Forum | Thu Nov 04 04:27:46 EDT 2010 | d0min0
thanks for all the feedback... we also checked, just in case : - bake the components (no visible improvement) - bake the pcb (50% less tombstone components) - finally we changed LF paste to completely different manufacturer - and booom 0 (zero) tombs
Electronics Forum | Thu Oct 28 11:50:11 EDT 2010 | phase1
We are having a little trouble with what appears to be a crystalization between our fine pitch parts. The problem appears after a a thourough wash of the pcb when dry. It looks like lead wiskers/haze between the joints.We are using water soluable lea
Electronics Forum | Sun Nov 14 14:14:47 EST 2010 | methos1979
On the bare boards, no paste, just a bare FAB board. We get them from a PWB manufacturer and inspect them to IPC-A-600 and then ship them to another manufacturer to populate them and we then inspect them to IPC-A-610. I have written several program
Electronics Forum | Wed Dec 29 13:45:08 EST 2010 | methos1979
Chris, The red/blue filter as you call it (on the MV3L it's called HorzVert Sum I think) has become my go-to light source view for manual visual evaluation of flagged solder defects. Of all the lighting sources available, this one gives me the best
Electronics Forum | Mon Jan 10 18:08:29 EST 2011 | eadthem
vpblf I actually installed the Uniserver (apache mysql php) WAMP on the AOI machine and there is a setting to make it generate HTML board results, cant remember where off the top of my head. anyhow anyone in the inspection area can now open firefo
Electronics Forum | Tue Jan 11 13:12:58 EST 2011 | methos1979
Has anyone had any luck programming using the side cameras to inspect for defects on the sides of chip components? We recently had an escape of a damaged chip capacitor that was impossible to see from the top camera but was clearly visible with the
Electronics Forum | Thu Jan 13 10:30:40 EST 2011 | bdamico
Hello Scott, Simply program the side angle cameras as you would for any other device using the downward camera. For instance, solder joint inspection for a PLCC would utilize a basis window, bridge inspection algorithm and individual solder joint i
Electronics Forum | Thu Jan 13 20:40:47 EST 2011 | eadthem
properties > settings > troubleshooting > Set hardware acceleration to NONE > apply OK apply OK reboot. without this any attempt to take a screen shot of the program will not save the image (because in a fruitless attempt to speed it up they have pr
Electronics Forum | Wed Jan 19 12:54:17 EST 2011 | bdamico
Hello Mark, The centroid data you are currently using to program the MV-2HTL may be used with either platform. However, the libraries cannot be shared due differences in camera resolution. The MV-2HTL will have a 1.3 megapixel camera versus the 2 m
Electronics Forum | Fri Nov 05 11:30:53 EDT 2010 | deanm
We have a Quad QSV-1 pick and place machine that has performed fine for us with the exception of cylindrical glass (MELF) type diodes. The machine often fails to pick these out of the tape to the point where it is easier to hand place them. As far