Electronics Forum | Thu Sep 08 05:36:25 EDT 2016 | hyng
Hi guys, Which brand of offline AOI is better? Any advice? My budget is around 40K USD. Now i'm looking at Marantz (Japan), Jutze (China) and Magicray (China).
Electronics Forum | Tue Sep 13 02:31:50 EDT 2016 | bukas
board input sensor sensitivity? maybe conveyor movement triggers it and because of that it sends pulse. conveyor moves few millimeters, how does machine act?
Electronics Forum | Tue Sep 13 07:32:51 EDT 2016 | bukas
that sounds like bad relay or relay control. are you in position to check it on relay pins? I would go from there.
Electronics Forum | Wed Sep 14 23:30:30 EDT 2016 | ariss_t
Hi, my 2cent.. u could try to check the sensibility of the camera board stop sensor.. maybe it detect something i.e support block.. do reply when u found the actual root cause.. thanks..
Electronics Forum | Thu Sep 15 11:18:04 EDT 2016 | cyber_wolf
When you attach multiple modules to the manifold, this is the only one that screws up ? It sounds like something maybe hooked up backwards.
Electronics Forum | Fri Sep 16 08:59:38 EDT 2016 | cgreiner
Phil, I had the same problem with my Gridlok blocks. Contact Jean Schroy at Henderson Industries in Bethlehem, PA (610-758-9263). They refurbished the three that I had and they have been working perfectly ever since. Best Regards
Electronics Forum | Mon Sep 19 10:17:53 EDT 2016 | emeto
I bet you it is a gasket that needs to be aligned or replaced(also could be as broken tube, if any). The only question is, how far you should dig in to find it? I would say, keep disassembling.
Electronics Forum | Tue Sep 20 03:04:11 EDT 2016 | sarason
One of the wonderful things about a part going obsolete, if you have stock often the price will rise ten times over your buy, good when selling, not so good if you are running a reasonable volume on an old but good selling product! sarason
Electronics Forum | Wed Sep 28 02:58:00 EDT 2016 | leadthree
I have them online and as aspected the feedback is zero. Still looking at other methods. I am aware that they might be very valuable to somebody in need - but to find that one is rather difficult. I'm not a huge friend of brokers, I bought fake par
Electronics Forum | Thu Sep 15 10:49:58 EDT 2016 | emeto
Remove,clean, re-ball(or use new part), reflow. Body of the part is designed to withstand heat that is higher than the melting point of the balls alloy.