Electronics Forum | Wed Jun 02 13:13:41 EDT 1999 | Tim
ok, ok, so I'm not an engineer. I'm a salesguy ( and that's nothing to be ashamed of...) Here's my dilemma. I represent a contract manufacturer who is in the early stages of quoting on "turnkey" assembling of a circuit board for a manufacturer of
Electronics Forum | Mon Jun 07 15:48:14 EDT 1999 | Tim
Thanks to all for the input. Earl's was the wackiest, what with the mention of "hollywierd" and " safe sex." Just to set the record straight, I never said we had no process controls. What I said was that I am in the middle. My factory uses one ty
Electronics Forum | Wed Jun 02 09:50:00 EDT 1999 | Earl Moon
| Hello all | I have a question concerning whether or not there is any special requirements to follow for assembly of a Polyimide PCB card. The customer has the following information on there documentation but since we have never built anything with
Electronics Forum | Wed Jun 02 09:55:31 EDT 1999 | Jason Gregory
Hello Dan, I have recently started using polyimide, but not for the standard uses. I designed a pallet for holding small, thin (about .0018" thick) RF boards that were being reflowed inside their aluminum housings. They were screwed down to prevent w
Electronics Forum | Tue Jun 01 11:43:25 EDT 1999 | Dave F
| Hi, | | To improve the Design For Manufacturing I am currently looking to write down some design rules that can (and should be) used by our engineering department. | | Can somebody help me get started or give some usefull tips on where to find a
Electronics Forum | Tue Jun 01 15:35:03 EDT 1999 | Earl Moon
| Hi, | | To improve the Design For Manufacturing I am currently looking to write down some design rules that can (and should be) used by our engineering department. | | Can somebody help me get started or give some usefull tips on where to find a
Electronics Forum | Sat May 29 22:20:56 EDT 1999 | Earl Moon
| | Is it possible to place parts that do not have leadframes exposed when looking from the top side of the part such as BGA's using a Fuji IP1 with a SMD1 vision (Binary) system. I realize that the IP1 does not have front lighting but according to a
Electronics Forum | Sat May 29 22:10:28 EDT 1999 | Earl Moon
| We are looking into frameless stencil systems for screen printing. Outside frame size of 29x29. | | Pros: smaller storage requirements and cheaper stencils. | | Cons: sharp metal edges, additional change over time required | | Can anyone relay
Electronics Forum | Fri May 28 15:01:02 EDT 1999 | Tony
| Has anyone had experience with prototype-scale, table top Placemax and/or Manncorp pick and place equipment? If so, what has been your experience with the machines? Are they reliable? Did they meet all your needs? Which needs didn't they fill?
Electronics Forum | Fri May 28 16:03:10 EDT 1999 | Jeff Sanchez
| Has anyone had experience with prototype-scale, table top Placemax and/or Manncorp pick and place equipment? If so, what has been your experience with the machines? Are they reliable? Did they meet all your needs? Which needs didn't they fill?