Electronics Forum | Wed Jun 21 10:06:19 EDT 2000 | ehab
I believe the training was just a couple days after the installation. It really depends on how many people will be trained and previous machine programming experience. Programming the machine is not that hard; however, it's time consuming sometime.
Electronics Forum | Wed Jul 09 16:09:47 EDT 2003 | russ
I would always recommend that an oven be used. I am not familiar with the ERSA rework system so I cannot comment. The key is to heat evenly with the correct ramp rate. If your rework station does this well then use it. if not I would put through t
Electronics Forum | Mon Nov 05 00:51:58 EST 2007 | omidjuve
We have a problem with soldering of a 96 pin header connector(9001-11961c00l1a from kingmate) we use 3 different wave soldering but in all of the machines we have many short circuit between the pins . the wave soldering machines that we use is fr
Electronics Forum | Mon Jul 08 13:10:55 EDT 2013 | rgduval
As with any issue like this, your miileage may vary with suggestions....but, here are the items I would consider: 1. Clinch tightness. I believe IPC gives a recommendation on the amount of bend in a clinched lead; make sure you're not beyond that.
Electronics Forum | Thu Jun 10 13:29:21 EDT 2021 | edgar_smt_ap
Good morning. What should be the Oxygen content Standard in an Oven? Here in my company, we have an ERSA reflow Oven, and we work with Lead Free solder paste. According to Work Standard documents send by my company corporate, the PPM Oxygen conte
Electronics Forum | Tue Jun 16 15:06:48 EDT 1998 | Bob Willis
I must say that I feel when the board has been correclty designed with corner marks on the edge of the BGA the optical systems are not necessary on 0.50/0.060" pitch. I like both air and IR the IR has the major benifit that you do not need all the ex
Electronics Forum | Tue Aug 22 03:04:07 EDT 2006 | PP
Any help/suggestion is much appreciated I am doing lots of BGA Reworks from a small uBGA with a few balls to a large BGA with over 1500 balls. The reworks have been done on SRT 1100 Series Machine for many years. SRT 1100 Machine is good for the c
Electronics Forum | Thu Nov 16 20:17:53 EST 2006 | billwestiet
James, Looks like you are getting a lot of advise from Electrovert to Ersa and Seho to some imported Chinese machine. There are more optsions today than ever, I should know I offer one (www.ietechnology.net). What are you trying to accomplish with
Electronics Forum | Sat Jun 24 07:23:06 EDT 2017 | tch
You will need to preheat the boards for a lead free selective solder process. A preheat module is critical for any wave or selective solder process, if you don't get the board preheated properly the solder is going to resist flowing to the top of the
Electronics Forum | Fri May 11 09:17:12 EDT 2018 | charliedci
I have used a 2006 Electrovert Vectra ES (63/37) for last 3 years, we acquired it used. It had little or no maintenance before we got it, now after replacing a solder pump motor, preheater fans and thermocouples it is pretty reliable. The spray fluxe
